What is P1164?
|P1164 HONDA Meaning The Air/Fuel Ratio (A/F) sensor 1 is installed in the exhaust system and detects oxygen content in the exhaust gas. The ECM compares a set target air/fuel ratio with the detected air/fuel ratio and controls the fuel injection timing.
What does p0134 mean on a Honda CRV?
P0134 is a relatively common OBDII trouble code. It’s generic, which means that it has the same meaning for any vehicle with OBDII. It means that the PCM/ECM is
How much does it cost to repair a Honda p1166 code?
The cost of diagnosing the P1166 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
What does no activity mean on Honda CRV O2 sensor?
Honda CR-V P0134: O2 Sensor → No Activity Detected B1S1. P0134 is a relatively common OBDII trouble code. It’s generic, which means that it has the same meaning for any vehicle with OBDII. It means that the PCM/ECM is not detecting any activity from the sensor.
What is the fault code for a Honda Accord?
P1297 Electric Load Detector (ELD) Circuit Low Voltage P1298 Electric Load Detector (ELD) Circuit High Voltage P1300 Random Misfire P1324 Knock Sensor Power Source Circuit Low Voltage P1336 Engine Speed (RPM) Fluctuation Sensor Intermittent Interruption P1337 Engine Speed (RPM) Fluctuation Sensor No Signal
Where is the leak code on a Honda CRV?
Nytro97 is right usually the vent solenoid valve that rust out from the top where the 4 bolts sits & seals it. You can use soapy water to test it if it has a leak. But if you see rust , then just replace it. If you need a diagram I can give you a link on where to find it.
How to remove EVAP code from Honda CRV?
Jack up the rear and put on tall jack stands. Remove the skid plate which is 3 10mm bolts, 2 on the front 1 on the rear. Remove the 3 bolts 12mm bolts holding the canister. The 2 at the rear of the canister are easily accessible with the socket wrench.
What causes a Honda CRV canister to leak?
I had this on my 2002 CRV a few years back. It is probably the canister shut valve. My shut valve tested good electrically…my problem was corrosion of the metal that held it together. It was just leaking. It sits right next to the canister. I did it right in my garage, jacked up the left rear and set a jack stand for safety.