What is a progressive spring?
Progressive-rate coil springs are also called variable-rate coils springs, and have a spring rate that increases as the coil compresses from free length (unloaded). Not only do progressive springs give a smoother ride over small bumps, but they also make the suspension stiffer more quickly as it compresses.
Does lowering a bike affect handling?
Effects on Handling Even if you lower your bike by the book, handling can be affected to some degree. “When you lower a bike, you also lower its center of gravity, so it’ll handle a bit better in certain circumstances,” says Langley. “The negative is that your initial ground clearance is decreased.
Is it possible to lower the FRT on an ultra glide?
I believe it would make the bike look really good also. If you are thinking inches lower you will be unable to ride bike. Front has about 4.5 inches and rear has 3 inches of travel. At best lowering the frt and rear 1″ will help but compromise the ability of the Ultra both in ride and handling.
How to lower a Harley Davidson Ultra glide classic?
Somethimes the key here “adjustability” and matching it to the “application”…are you going to be primarily “2-Up riding”, you then what to be able to stiffen the preload and raise the ride height of the bike ladened (so get the total weight of you, passenger and cargo and go to suspension house like Progressive for the best PLAN…)!
How do you tighten the front axle on a Harley Davidson?
Ensure that the fork slider cap bolts — or the axle pinch screw if you’re working on a Sportster — are loose enough to allow the axle to slide. Stick a screwdriver or steel rod through the hole in the right end of the axle to prevent the axle from turning. Torque the axle nut to 60 to 65 foot-pounds, using a foot-pound torque wrench and socket.
What to do about a soft front end on a Harley Davidson?
A popular choice to cure a soft front-end is to replace the fork springs with a set that more closely matches the rider’s weight and riding style. Many opt to install a set of upgraded progressive rate fork springs, which get stiffer as they are compressed, because they provide riding comfort while offering bottoming resistance and better handling.
Do you need a lowering kit for a Harley?
I ride the Harley almost exclusively two up with my wife. It has almost zero solo miles. As a result I have to keep the shock pumped up with air for her comfort. Gone. There are a few lowering kits out there, both for front and rear.
Can you change the front end of a Harley Davidson?
Harley-Davidson has designed and manufactured this custom front end according to our very stringent and well-tested standards. If you modify the FLSTS Springer front end in any way that changes our original design, Harley-Davidson cannot and does not assume responsibility for mishaps resulting from these changes. 1WARNING
How to install a flsts springer front end?
USE THE APPROPRIATE SERVICE MANUAL PROCEDURES. If the procedure is not within your capabilities or if you do not have the correct tools, have your Harley-Davidson Dealer perform the installation. 1WARNING The components of your FLSTS Springer front end and their design relationship to each other are very important.
Can you lower the seat on a Harley?
Lowering the bike may not fix your issue completely as the width is what most of us Touring owners complained about. Check your seat and see if it is stamped “low” if not, replace it. If it is call Alan at Mean City Cycles: