What is a P0325 fault code?
Code P0325 Meaning When the engine “knocks” there is an excessive amount of NOx that is released. When trouble code P0325 is set, this means that the knock sensor 1 in Bank 1 is not operating properly.
What does the p0325 code on a check engine mean?
P0325 means that there is a malfunction within the knock sensor 1 in circuit bank 1. This malfunction will be detected by the ECU when it does not receive the proper information from the knock sensor. This triggers a Check Engine Light to be illuminated on the dashboard. What causes the P0325 code? What are the symptoms of the P0325 code?
What does a p0100 diagnostic trouble code mean?
This P0100 diagnostic trouble code (DTC) means that there is a detected problem with the Mass Air Flow (MAF) sensor or circuit. The PCM detects that the actual MAF sensor frequency signal is not performing within the normal expected range of the calculated MAF value.
What are the symptoms of a p0325 knock sensor malfunction?
The Check Engine Light illuminating on is normally the most noticeable symptom. The engine may have a slight lack of power. There may be no felt symptoms with P0325.
What causes MAF sensor to have trouble code p0101?
Potential causes for this trouble code may include: MAF sensor electrical harness or wiring problem (open, shorted, frayed, poor connection, etc.) Note that other codes may be present if you have a P0101.
What does a code p0325 mean on a knock sensor?
A code P0325 most likely means one or more of the following has happened: The knock sensor is faulty and needs to be replaced There is a wiring short/fault in the knock sensor circuit The PCM powertrain control module is failed
What are the p0120 and p2135 codes?
I have 2 codes P0120 and P2135, I first replace the pigtail and TPS sensor same problem and codes (Reduced engine power). so i bit the bullet and replaced the throttle body along with another new TPS (it came attached ) still same problem…any help?… codes P0340 and P0120 please help!
This P0100 diagnostic trouble code (DTC) means that there is a detected problem with the Mass Air Flow (MAF) sensor or circuit. The PCM detects that the actual MAF sensor frequency signal is not performing within the normal expected range of the calculated MAF value.
Potential causes for this trouble code may include: MAF sensor electrical harness or wiring problem (open, shorted, frayed, poor connection, etc.) Note that other codes may be present if you have a P0101.