What happens when you set cruise control on a Hyundai Elantra?
If you set cruise control, the rpms will jump by 500 or more. The jump in engine speed is maintained, not temporary. The sustained increase in engine speed will reduce fuel economy and increase mechanical wear on the vehicle. This issue has been present since the vehicle was purchased brand new.
Why is the cruise control on my car not working?
Common Causes of Cruise Control Not Working. 1) Cruise Control Switch; 2) Brake Light Switch; 3) Blown Fuse; 4) Check Engine Warning Light; 5) Vehicle Speed Sensor; 6) Electrical Issues
Are there any problems with the Hyundai Elantra?
Hyundai Elantra owners have reported 35 problems related to cruise control (under the vehicle speed control category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Hyundai Elantra based on all problems reported for the Elantra.
Can a brake light disengage cruise control?
Brake Light Switch – As cruise control is automatically cancelled by depressing the brake, some vehicles may disengage cruise control if it cannot detect the brake light switch. Brake Lights – In some systems, cruise control is disabled when a brake light is blown.
Why does my cruise control not work properly?
john b , Defective speed sensor, bad cruise switch/wire connection, bad brake light switch,etc can cause cruise not to work properly. If engine light on, record the code to help diagnose the issue. You may have to find a good Tech. to diagnose and estimate repair. Good luck.
What to do if your Cruise Control is broken?
Using a fuse puller, pull the fuse off the panel. Examine the cruise control fuse or use a fuse tester to determine if the thin metal strip inside the fuse is broken. If so, install a fresh fuse of the same amperage. A cruise control mechanism has a vacuum-powered actuator connected to the control module by vacuum lines.
Where is the fuse for the cruise control?
The cruise control fuse is normally found in the fuse panel located below the steering wheel. Remove the cover of the fuse panel and locate the fuse for the cruise control using the fuse diagram on the fuse panel.
Is there a support line for Rostra cruise control?
After I installed it on the bike I went for a ride on the interstate to test the unit. After about 10 miles the unit canceled the set speed. I set it again and after a few miles if canceled the set speed again. I called the support line and my call was answered by an English speaking support person after three rings. I explained my issues.