What happens when you hit a pothole on a golf course?
Imagine you are on a golf course, and you’re putting on the 18 th hole. If you hit your ball perfectly, it will fall into the cup near the end of its roll. If you hit the ball too hard, but right on line, your ball may hit the far edge of the cup and ricochet away.
Why do I hear a bang when I drive over a bump?
If the bushing wear down, the noise is not dampened and you may hear a resulting bang when driving over bumps. Loose Brake Caliper: Your vehicle’s brake calipers are pistons that engage the brakes when the brake pedal is applied. Calipers are typically secured with bolts and do not move.
Why did the ball not go in the hole?
The ball didn’t go in the hole because it was going too fast and didn’t have enough time to drop. The same rules apply for hitting a pothole. The faster you hit the pothole, the less time your wheel will have to drop into the hole. The slower you hit a pothole, the further your wheel will sink into the hole before hitting the other side.
What makes a golf club make a rattling sound?
Golf club manufacturers usually use rat glue to ensure that the particles that cause the rattling sound get stuck to it. The glue normally eliminates any noises from occurring. However, sometime the particles will break apart from the glue and start rattling around. This is the sound you hear in a club.
Why does my golf cart make a buzzing noise?
If you experience the buzzing noise even after the cart is switched off, it could be due to water on the battery wires. The buzzer might drain out the battery if you don’t find a way to switch it off. The wires from the buzzer could have got short-circuited and this could cause the buzzing sound.
What should I do if my golf shaft is rattling?
The simplest solution to fix a rattling sound in your shaft would be to remove the grip from the golf club. After removing the grip, you should be able to remove the particles, therefore stopping the rattling noise. Sometimes, even small pieces of rock or stones could have gotten inside the shaft during a game.
Why does my iron driver make a rattling noise?
Unlike wedges or drivers, the rattle in iron might not be caused by the epoxy glue getting loose. Although, the glue in the shaft might have become a bit loose and move up and down the shaft causing a noise. So, if you hear some rattling noise in the shaft, it could again be due to the epoxy glue.