What happens when the starter fails on a Harley Davidson?
The magnet pulls a contact into the closed position and high current is available to the starter. Release the ignition switch to de-energize the electromagnet and stop current flow to the starter. * Failure of the energizing circuit. The relay is effectively “dead” when this circuit fails. Attempting to start the engine will be unsuccessful.
Why is the starter not engaging on my V-twin?
The starter motor is getting the power from the battery and the motor is spinning, but the shaft that extends out from the starter and makes contact with the gear on your clutch is not engaging. There can be a couple causes for this, but I can’t remember them all.
What does Softail mean on a Harley Davidson?
Harley Davidson Softail will not crank refers to when the crankshaft will not turn so as to start the engine. In other words, not only will the Softail engin… Harley Davidson Softail will not crank refers to when the crankshaft will not turn so as to start the engine.
Why does the starter not engage when clutch is good?
The jack shaft will not engage unless the clutch is good. Correction, the jack shaft will engage with the clutch ring gear, but will not turn the engine over if the overrunning clutch is slipping. I had the same problem, would work some times and not other times, made a whirrrrring noise! I am going to assume your bike is about 87 or newer.
Why does my starter not work on my Harley Davidson?
If you press the start button and it just clicks and sounds like the starter drive gear does not align with the flywheel and does nothing, I cross the lugs at the starter relay and it throws the starter clutch drive gear into the flywheel and tries to start but will not stay engaged to turn the engine or just spins.
What should I do if my starter motor is out?
Like he said, most likely is your battery. However, when the hold in coil is out on the starter solenoid it will do the same thing that you are just describing. In that case you need a new starter motor or you could try to rebuild your solenoid. The starter motor and is very easy to swap out. First, disconnect your battery. Do not skip this step.
What are the symptoms of a bad starter?
Symptoms: When starter button is pressed there is a click and nothing happens or the starter drive tries to engage and then does not stay engaged. There is a lot of racket and noise like gears grinding.
Why does my starter click when trying to start?
The starter will either push the jack shaft out and spin (then the starter is good )or the jackshaft will click in and out rapidly and then you’ll know it’s the solenoid hold in coil. But it’s probably just the battery. Was this answer helpful?