What does the p2122 OBD-II trouble code mean?

What does the p2122 OBD-II trouble code mean?

The P2122 OBD-II trouble, or fault, code means that the vehicle’s on-board computer has detected low voltage in the throttle position sensor (TPS), which is usually below 0.17 volts. What the P2122 code means The registration of the P2122 trouble code simply means that low voltage has been detected in the TPS.

What does the trouble code p2138 stand for?

The automotive trouble code P2138 throttle/pedal position sensor/switch D/E voltage correlation refers to a problem related to the throttle’s ability to open and close properly. In the 1990’s automotive manufacturers began industry-wide installation of “Drive by wire” throttle control technology.

What is the p2138 code on a Pontiac Grand Prix?

Hi all, I have a 2007 Pontiac Grand Prix with sunroof which is throwing code P2138. This has been going on for nearly a year now. When driving in rain or very wet road conditions the Reduced Engine Power message will come on along with the check engine.

The P2122 OBD-II trouble, or fault, code means that the vehicle’s on-board computer has detected low voltage in the throttle position sensor (TPS), which is usually below 0.17 volts. What the P2122 code means The registration of the P2122 trouble code simply means that low voltage has been detected in the TPS.

What does a p2122 mean on a TPS sensor?

A P2122 code means that the the car’s computer has detected that the TPS (throttle position sensor) is reporting too low a voltage. On some vehicles that lower limit is 0.17 – 0.20 volts (V). The “D” refers to a particular circuit, sensor, or area of a particular circuit. Did you adjust it when you installed it?

What does the code P2106 mean on an engine?

What the P2106 code means. P2106 is an OBD-II generic code for the engine control module (ECM) detecting a major failure in a system causing the ECM to go into failure mode and limiting the throttle actuator to limited power.

The automotive trouble code P2138 throttle/pedal position sensor/switch D/E voltage correlation refers to a problem related to the throttle’s ability to open and close properly. In the 1990’s automotive manufacturers began industry-wide installation of “Drive by wire” throttle control technology.

What is the p2138 code on GM vehicles?

GM has issued a technical service bulletin # 07-06-04-019D to address a P2138 Reduced Power issue. The P2138 trouble code may be stored in the computer along with a check engine light. The P2138 Reduced Power bulletin applies to the following vehicles:

What is the Nissan Versa code p2138 code?

All tested well. replaced… 2007 nissan versa code P2138 ran the diagnostic trouble tree.. All tested well. replaced APP sensor same issue, had noticed app sensor 1 and app sensor 2 are reading the same voltage .7v off throttle 4.5v depressing throttle.

What does trouble code p2128 mean on a GMC Sierra?

The P2128 trouble code refers to Accelerator Pedal Position (APP) Sensor 1-2 Correlation. Do NOT assume you have a bad accelerator pedal sensor. GM says the condition is caused by water leaking into the body harness connector that carries the APP signal to the PCM. The water changes the voltage readings from the APP.

Why does my Nissan Murano not start up?

Found that the issue is related to the brake pedal interlock which shuts down the electrical system. After 64 days at dealership to replace faulty air bags I retrieved my car today.

When to use the trouble code p2138 on a computer?

The computer monitors the correlation of both voltages. When both voltages agree, the system is functioning properly. When they deviate for two seconds, the code P2138 is set indicating a malfunction somewhere in the system. Additional trouble codes may accompany this code which further identify the problem.

All tested well. replaced… 2007 nissan versa code P2138 ran the diagnostic trouble tree.. All tested well. replaced APP sensor same issue, had noticed app sensor 1 and app sensor 2 are reading the same voltage .7v off throttle 4.5v depressing throttle.

Posted In Q&A