What does the p0507 Nissan ECM code mean?
P0507 NISSAN Meaning The Engine Control Module (ECM) controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine idling speed.
What causes idle RPM on Nissan Altima p0507?
It would be a good idea to start by looking for a vacuum leak and move forward from there. A leaking vacuum system will often cause the Altima to idle higher. When the vacuum system leaks, it allows extra air to enter into the combustion chamber. This air allows for a slightly higher combustion, increases the RPM and throws the code.
What does idle air control code p0507 mean?
It is typically triggered when the engine idle speed is 200 rpm or more over the predetermined limit set by the manufacturer. It is a generic code, which means that it has the same for the Nissan Altima as any other vehicle. Unlike many OBDII trouble codes, P0507 will typically be noticeable to you when driving.
What does DTC stand for on Nissan p0507?
They rely on sensors and electronics to control the throttle. In this case, the P0507 Nissan DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is greater than the desired (pre-programmed) RPM.
It is typically triggered when the engine idle speed is 200 rpm or more over the predetermined limit set by the manufacturer. It is a generic code, which means that it has the same for the Nissan Altima as any other vehicle. Unlike many OBDII trouble codes, P0507 will typically be noticeable to you when driving.
It would be a good idea to start by looking for a vacuum leak and move forward from there. A leaking vacuum system will often cause the Altima to idle higher. When the vacuum system leaks, it allows extra air to enter into the combustion chamber. This air allows for a slightly higher combustion, increases the RPM and throws the code.
What causes idle air control code on Nissan Altima?
While the code specifically mentions the “Idle Air Control System”, it would be a mistake to just go ahead and replace it without a little due diligence. The Idle Air Control Valve is often not the cause of the code. Here are some of the most common causes of P0507 in the Nissan Altima, as well as waist to troubleshoot them.
How much does it cost to repair a Nissan p0507?
Please try again later. The cost of diagnosing the P0507 NISSAN code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What should I do if my Nissan Altima Idles?
P0507 2004 NISSAN ALTIMA SEDAN Tech Notes If there are no intake leaks, clean throttle body, adjust engine idle and erase engine code. If the code comes back you may have to replace the Electric Throttle Control Actuator (Motor) to repair the problem.
When is the p0507 2003 Nissan Altima sedan code detected?
What does this mean? The cost of diagnosing the P0507 2003 NISSAN ALTIMA SEDAN code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P0507 2003 NISSAN ALTIMA SEDAN code detected?
P0507 2004 NISSAN ALTIMA SEDAN Tech Notes If there are no intake leaks, clean throttle body, adjust engine idle and erase engine code. If the code comes back you may have to replace the Electric Throttle Control Actuator (Motor) to repair the problem.
How is the ECM of a Nissan Altima determined?
The optimum value stored in the ECM is determined by taking into consideration various engine conditions, such as during warming up, deceleration, and engine load (air conditioner, power steering and cooling fan operation, etc.) Need more information on how to fix the P0507 2004 NISSAN ALTIMA SEDAN code?
While the code specifically mentions the “Idle Air Control System”, it would be a mistake to just go ahead and replace it without a little due diligence. The Idle Air Control Valve is often not the cause of the code. Here are some of the most common causes of P0507 in the Nissan Altima, as well as waist to troubleshoot them.
When to use the p0507 code on your car?
The P0507 code is triggered when the Engine Control Module ( ECM) detects that the engine is idling higher than the specified idle rpm range. The standard engine idle is usually between 600-800rpm based on the model of the vehicle.
When is the p0507 idle air control system higher than expected?
In this case, the P0507 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is greater than the desired (pre-programmed) RPM.
What are the symptoms of code p0507?
Defective PCV Valve – If the PCV (positive crankcase ventilation) valve is stuck open, it will apply manifold vacuum to the crankcase, which may start sucking in air almost anywhere, such as from the dipstick tube or valve cover gasket. What are the symptoms of code P0507 ?
Please try again later. The cost of diagnosing the P0507 NISSAN code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much does it cost to fix error code p0507?
Estimated Cost of Repair. For error code P0507, one or more of the below repairs may be needed to solve the underlying issue. For each possible repair, the estimated cost of repair includes the cost of the relevant parts and the cost of labor required to make the repair. Clean Throttle Body $150-$250 labor $20-$40 in parts
How to idle and relearn Nissan p0507?
Wait EXACTLY 7 seconds and press the pedal and keep it depressed for about 10 seconds until the check engine light starts blinking. If the check engine doesn’t blink after 20 seconds, turn the key to the OFF position. Wait at least 10 seconds and begin the procedure from the start.
Why does my DTC p0507 have idle speed control?
Depending on year, make, and model, DTC P0507 may have number of causes. Here are some of the most common. ECU Update – Newer vehicles, particularly those with drive-by-wire electronically-controlled throttle bodies, may not be equipped with an individual IAC, but use the main throttle valve to maintain idle speed.
What does the idle control system code p0507 mean?
What the P0507 code means. The P0507 code means the idle control system has excessively high RPM. The ECU has a specific rpm range the idle is allowed and when it is higher than expected the ECU sets the P0507 code. Once this code is triggered it puts the vehicle into a failsafe mode and the Check Engine Light is illuminated on the dashboard.
Wait EXACTLY 7 seconds and press the pedal and keep it depressed for about 10 seconds until the check engine light starts blinking. If the check engine doesn’t blink after 20 seconds, turn the key to the OFF position. Wait at least 10 seconds and begin the procedure from the start.
How to fix a p0507 power steering problem?
1 Replacing or cleaning the idle air valve 2 Repairing the intake air leak 3 Repairing the charging system 4 Cleaning the throttle body 5 Replacing the power steering pressure switch
How does a p0507 trouble code work on a Nissan?
Over time, carbon builds up on the throttle plate and in the throat of the throttle body, the ECM adjusts throttle plate opening to compensate for the buildup. At a certain point, the ECM can no longer compensate and sets a P0507 trouble code.
What to do when ECM says p0507 trouble code?
At a certain point, the ECM can no longer compensate and sets a P0507 trouble code. You must remove the electronic throttle body to clean it. Apply throttle body cleaner to a clean rag and wipe the carbon off the throat and throttle plate.
Can You Spray throttle body cleaner on the intake manifold?
Do NOT EVER spray throttle body cleaner directly onto the throttle plate. The cleaner can wick into the electronics and damage them. Once the throttle body has been cleaned, reinstall on the intake manifold using a new gasket and proper torqueing procedures. Then perform an idle relearn procedure.
What is the code for idle speed control?
Hey Kev2: When AutoZone read me the code 0751 because I asked why my ETS light was on, I assumed they were related. Went back to AutoZone today and got more details. The P0751 is for the shift solenoid valve failure. They also found P0507 for the Idle Air Control (IAC) saying engine idle speed is… Hello All, I have a 1996 Chevy Lumina]
P0507 NISSAN Meaning The Engine Control Module (ECM) controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine idling speed.
The role of the Idle Control System is to manage the engine’s idle speed and meet the fluctuating load placed on the vehicle’s engine, which varies from the use of air-conditioning, heater, wiper, etc. Error Code P0507 means the idle speed is faster than normal.
What does the idle control system code mean?
The role of the Idle Control System is to manage the engine’s idle speed and meet the fluctuating load placed on the vehicle’s engine, which varies from the use of air-conditioning, heater, wiper, etc. Error Code P0507 means the idle speed is faster than normal. This code is sometimes triggered on vehicles with electronic throttle control.