What does the ABS light mean on a Chevy Silverado?
The ABS light is different than the brake warning light itself. The brake light indicates that there is a problem with the physical braking system and that your Silverado is unsafe to drive. Yes, you can drive your Silverado with the ABS light on. Is it safe?
Why is my abs light not working on my Chevy Cobalt?
The antilock brake system runs through the ABS module. This module physically controls the anti-lock brake system If it becomes damaged, and can no longer control all four brakes, the ABS light will activate. Typically, corrosion is the most common reason why the module fails.
Where is the parking brake light switch located?
that switch only turns on the parking brake light. even if it fails, it doesn’t cause the abs light to go on. It may be that the ground for the ABS computer needs cleaning/fixing. It is located on the ‘wing’ off the frame, right under the drives door.
Why is my brake light not working on my Chevy?
You may have code C0265 “Electronic Brake Control Module Motor Relay Circuit.”. The fault is usually due to broken solder joints on the circuit board. At this time I did not need to pull the EBCM and repair the solder.
The ABS light is different than the brake warning light itself. The brake light indicates that there is a problem with the physical braking system and that your Silverado is unsafe to drive. Yes, you can drive your Silverado with the ABS light on. Is it safe?
The antilock brake system runs through the ABS module. This module physically controls the anti-lock brake system If it becomes damaged, and can no longer control all four brakes, the ABS light will activate. Typically, corrosion is the most common reason why the module fails.
You may have code C0265 “Electronic Brake Control Module Motor Relay Circuit.”. The fault is usually due to broken solder joints on the circuit board. At this time I did not need to pull the EBCM and repair the solder.
that switch only turns on the parking brake light. even if it fails, it doesn’t cause the abs light to go on. It may be that the ground for the ABS computer needs cleaning/fixing. It is located on the ‘wing’ off the frame, right under the drives door.
Why does my abs warning light keep flashing?
Most ABS diagnostic codes can be accessed by the ALDL connector much like the engine computer control system. When this warning light flashes or stays on steadily it means the system is disabled.
What are the warning lights on a Chevrolet?
The following are warning lights and indicators found in vehicles built by Chevrolet. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray). There are nearly 50 of them so search carefully!
Why is the ABS warning light always on?
It sounds as if it is at the wheel end because of the water, but as bigiainw says that if it is a sensor it would bring on the other safety systems warning lights that rely on it. So yes get it checked with a dealers engine management tester that can check out the ABS system.
What does ABS light on, Trac off mean?
Repair Topics > Brakes > ABS light on, TRAC off,… ABS light on, TRAC off, Stabilitrac off – What does it mean?
What are the warning signs on a GM car?
If you own one of the GM vehicles listed below and have any of these warnings: ABS light on, TRAC off, Service Traction Control System light on, Service Stabilitrak light and/or have the following trouble codes stored; C0035, C0040, C0045, C0050, on you should read this service bulletin #PIC5248E from GM.
Why is the warning light on on my car?
If it turns out that at least one of the wheels is moving too slowly, the anti-lock braking system will increase the pressure of the brake fluid to allow the wheel to move at a normal speed. But if there is a problem with the speed sensor, the anti-lock braking system will detect that and cause the warning light to illuminate on the dashboard.