What does p2135 mean on a TP sensor?
P2135 means the voltage reading produced from the TP sensor and accelerator position sensor are far from each other, which means it’s inaccurate. The signal from each TP sensor and the accelerator position sensor must correlate to each other, or the code will be set. Similar error codes are:
What causes the 2135 code on a PCM?
What causes the 2135 code? 1 Faulty PCM 2 Faulty throttle position sensor (s) 3 Faulty accelerator position sensor 4 Disruption in the throttle position sensor circuit such as an open, corrosion, short, damaged wiring or broken electrical connections
What is the error code for the TP sensor?
The PCM will read this signal as how far the throttle plate is open. If on TP sensor is reading at half throttle and the other is reading at full throttle, the PCM will then set the Error Code P2135, because the voltage readings will be remote and impossible for the data to be accurate. The TP sensor is located on the throttle body inlet.
What causes p2135 code throttle / pedal Pos switch?
Potential Causes of P2135 DTC. It’s been my experience that the wiring connector or “pig tail” on the throttle body gives problems in the form of a poor connection.The female terminals on the pigtail corrode or pull out of the connector. Possible bare wire on pigtail shorting to ground.
What does the p2135 code on the throttle mean?
When they deviate for two seconds, the code P2135 is set indicating a malfunction somewhere in the system. Additional trouble codes may accompany this code which further identify the problem. The bottom line is, it can be a dangerous situation when control over the throttle is lost.
What causes the p2138 code on a TP sensor?
Many problems can trigger the P2138 code, from a defective TP sensor to faulty wiring in the accelerator pedal. It usually takes a seasoned mechanic to pinpoint its exact cause. However, if you are confident with your automotive repair know-how, you can try to diagnose the code yourself.
When does the throttle / pedal position sensor switch D?
It is triggered when the vehicle’s engine control module (ECM) or powertrain control module (PCM) detects that the signals from the two throttle position sensors (or two accelerator pedal position sensors) do not correlate.
How much does it cost to diagnose a p2135 code?
The cost to diagnose the P2135 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.