What does p0330 mean on a Toyota Camry?

What does p0330 mean on a Toyota Camry?

P0330 is a powertrain OBDII trouble code that has the same meaning for the Toyota Camry as it would any other vehicle. By definition, it means that the vehicles ECM/PCM isn’t getting the proper signal from the knock sensor. Clearing this code typically requires a new knock sensor.

What does the p0325 code on a Toyota mean?

The P0325 code means that the Knock Sensor is not working properly. Replacing the knock sensor usually takes care of the problem. What does this mean? The cost of diagnosing the P0325 TOYOTA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type.

How much does it cost to repair a p0330 Toyota?

The cost of diagnosing the P0330 TOYOTA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P0330 TOYOTA code detected? The knock sensor is attached to the cylinder block.

How much does it cost to repair p0325 Toyota knock sensor?

Most auto repairs shops charge between $75 and $150 per hour. When is the P0325 TOYOTA code detected? The Knock Sensor (KS) senses engine knocking (also known as detonation or pinging) using a piezoelectric element. The sensor is attached to the cylinder block, cylinder head or intake manifold.

How to test Toyota p0330 knock sensor codes?

Use a baer copper wire so you can get your test probe on it. Don’t short out the wires. Then put your multimeter on an AC setting and see if there is about 250mV or so. If you have a scope, that would be even better. 7.1KHz is a low frequency, but just see if you’re in the ballpark on both sensors.

When did Toyota replace the knock sensor codes?

Gotta get the thing smogged. 2001. knock sensor codes being thrown see picture. Replaced with new oem denso sensors and oem sub harness. Before putting it back together I tested resistance from the sensor plugs back to the ecu plug directly and found no issue there (thought it was odd both tripped at the same time is why i did this).

What was the knock sensor code for the Avalon ES300?

Avalon ES300 RX300 highlander sienna solara camry etc** 2001. knock sensor codes being thrown see picture. Replaced with new oem denso sensors and oem sub harness.

What does the knock sensor code p0330 mean?

The knock sensor monitors engine “knock”—this indicates that the engine is experiencing unusual combustion in the form of detonation or pre-ignition. Code P0330 may be set when your PCM detects a problem with the #2 knock sensor or its circuit. The knock sensor is usually bolted or threaded into the engine block.

What does DTC p0330 stand for in a car?

Diagnostic trouble code (DTC) P0330 stands for “Knock Sensor 2 Circuit (Bank 2).” It indicates that a malfunction has been detected with the #2 knock sensor or its circuit. The knock sensor monitors engine “knock”—this indicates that the engine is experiencing unusual combustion in the form of detonation or pre-ignition.

Where is the p0330 code stored in the PCM?

The PCM then uses the information to adjust the ignition timing in order to prevent more knocking. The P0330 code is stored in your vehicle’s memory when the PCM detects that the input voltage from the knock sensor 2 is either too high or too low. If left unaddressed, this error code could lead to more serious engine problems and damage.

Where can I get trouble codes for my Toyota Camry?

There are many ways to get the PCM to give you the trouble codes that have been set. Most auto supply stores will hook a code reader to your car for free. Their reader may not get to the inner depths of the PCM but should catch the common codes.

What does p0446 mean on a Toyota Camry?

P0446 points to the Evap system vent control circuit. This VSV is on the charcoal canister which means it’s under your car in a bad spot. Unfortunately if it is this, the entire canister must be replaced for $300+. Even pros have to disconnect a lot of parts to pull it. Figure 2. Tough place for a charcoal canister. Figure 3.

Posted In Q&A