What does no start when cold fuel pump mean?
No temp change, nothin. Check wires again, alls good. Hop on mud, do some more readin, pop out EFI 15 amp fuse, clean terminals (male and female), same procedure with EFI main relay, both are silghty to fairly corroded. Truck starts no prob on and off for the next hour.
Why does my fuel pump not prime when I turn it on?
Pulled fuel pump relay and put in a jumper wire to run the fuel pump and it started. Put the fuel pump relay back in and it starts and drives, but the fuel pump still doesn’t prime when turning the key on. I’m afraid that after sitting overnight, it will once again refuse to start.
How can you tell if your fuel pump is failing?
If you ignore all of the other warning signs of a failing fuel pump, it will eventually fail completely. Once your fuel pump has finally given up the ghost, no fuel will reach your engine. You may hear your spark plugs firing when you try to start your car, but without fuel, the engine won’t be able to turn over.
When do I turn ignition on fuel pump keeps running?
I don’t think anywhere in the thread he has said that the engine is turning over, only the hum of a motor running, which is most likely the fuel pump. However, he still should be able to get the engine to turn over with the starter, unless the battery voltage is low and the voltage circuit in the starter relay is keeping it from activating.
What causes the fuel pump to not start?
The fuel pump is running and delivering normal pressure to the engine But, with all that working your engine still will not start. So, the most likely cause, is that the fuel injectors are probably not opening. The (PCM) uses the trigger signal from the crankshaft position sensor; and/or camshaft position sensor to pulse the injectors.
Can a car start with no fuel in it?
Once your fuel pump has finally given up the ghost, no fuel will reach your engine. You may hear your spark plugs firing when you try to start your car, but without fuel, the engine won’t be able to turn over. Of course, there could be other explanations for your engine’s failure to start besides a failed fuel pump.
What should fuel pressure be when no Buzz?
Fuel pressure is typically in the 35 to 45 psi range. If your Anti-Theft light is flashing; the anti-theft system is disabling the fuel pump to prevent the engine from starting. Bad fuel pump (Pump should run for a few seconds when ignition key is turned to start, no buzz means no fuel delivery to the engine).
How can you tell if your fuel pump is dead?
Of course, there could be other explanations for your engine’s failure to start besides a failed fuel pump. To confirm that your pump has failed, check the pressure in your fuel lines with a fuel pressure gauge; if it reads zero, then your pump is likely dead.
What causes a car to not start with no gas?
Problem may be at wiring connector on top of fuel tank (hard to reach!). No gas in fuel tank (Check the fuel gauge, and keep in mind the gauge may not be reading accurately). Bad gas (Contaminated with water or too much alcohol or diesel fuel). If you just filled up with gas and now your car won’t start, suspect bad gas.
Why is the fuel pump relay not closing?
If jumping the fuel pump relay makes the pump run, and if the relay tests good. Then you need to determine why the ECM is not telling the relay to close. Start by testing continuity back to the ECM. Here is the electrical diagram for the 01 Tib Fuel Pump Relay
Pulled fuel pump relay and put in a jumper wire to run the fuel pump and it started. Put the fuel pump relay back in and it starts and drives, but the fuel pump still doesn’t prime when turning the key on. I’m afraid that after sitting overnight, it will once again refuse to start.
Why is the fuel pump not working on my Toyota pickup?
With the key in the ON position, i jumped TE1 and E1, and the check engine light just flashes repetitively. also, while in the ON position, i can not hear the fuel pump. however, when i jump FP and B+, you can immediately hear the fuel pump kick in. but when i try to start it again, it still fails just as before
If jumping the fuel pump relay makes the pump run, and if the relay tests good. Then you need to determine why the ECM is not telling the relay to close. Start by testing continuity back to the ECM. Here is the electrical diagram for the 01 Tib Fuel Pump Relay
Why does my Toyota pickup crank but not start?
This morning when i went to start up, it cranks but doesn’t start. you can actually kind of hear when it would normally fire up (after a couple cranks), but it just continues to crank after that. also, the check engine light has come on for the first time