What does no bus mean on the odometer?
RECENTLY HAD “no buS” SHOW ON THE ODOMETER IN MY 2000 JEEP WRANGLER. THE VEHICLE DID START AND RAN WITHOUT A PROBLEM, BUT WHO KNOWS FOR HOW LONG. THE ONLY RECENT CHANGE WAS A NEW BATTERY. Having the same problem on my ’99 Jeep Cherokee.
What does no bus mean on a jeep?
The reply stating that the battery was just changed makes me more suspicious that this is the cause. The no bus syndrome on the jeeps. Had one in the shop a no start with the fuel and amp gauge not working. The no bus signal on the odom.
Where is the no bus signal on the Odom?
The no bus signal on the odom. Pcm depends on an 8 volt ref to communicate through the bus line to the cluster to operate the dash and to communicate threw the aldl connecter. If any sensor shorts out the pcm goes dead and the no bus sign shows. On the rear drivers side top of bellhousing is the location for the crank sensor.
What does no bus mean on a Dodge Ram 1500?
“NO BUS” means that the communication system between the computers has stopped working. HELLO: I HAVE THE SAME PROBLEM WITH MY 2001 Dodge RAM 1500 PICKUP. THE DEALER WANTS 85 DOLLARS AN HOUR TO FIGURE IT OUT. Hi I have a 2000 Ram 1500 that had the same problem.
RECENTLY HAD “no buS” SHOW ON THE ODOMETER IN MY 2000 JEEP WRANGLER. THE VEHICLE DID START AND RAN WITHOUT A PROBLEM, BUT WHO KNOWS FOR HOW LONG. THE ONLY RECENT CHANGE WAS A NEW BATTERY. Having the same problem on my ’99 Jeep Cherokee.
The reply stating that the battery was just changed makes me more suspicious that this is the cause. The no bus syndrome on the jeeps. Had one in the shop a no start with the fuel and amp gauge not working. The no bus signal on the odom.
The no bus signal on the odom. Pcm depends on an 8 volt ref to communicate through the bus line to the cluster to operate the dash and to communicate threw the aldl connecter. If any sensor shorts out the pcm goes dead and the no bus sign shows. On the rear drivers side top of bellhousing is the location for the crank sensor.
Where is the bus located on a jeep?
ON JEEP DODGE CHRYSLER VEHICLES COMPUTERS COMMUNICATE WITH ONE ANOTHER ACROSS THE “BUS”. THE BUS IS CONTROLLED BY THE BODY CONTROLLER. DOUBLE CHECK ALL FUSES IN PDC (POWER DISTRABUTION CENTER) UNDER HOOD AND FUSE CENTER UNDER DASH.
Why is my airbag light not working on my Jeep Wrangler?
This condition is caused by minor oxidation of the BUS circuit terminals at the instrument cluster connector. Electrical terminals will show signs of oxidation, which will appear as darkened lines or marks on the cluster male terminals.
ON JEEP DODGE CHRYSLER VEHICLES COMPUTERS COMMUNICATE WITH ONE ANOTHER ACROSS THE “BUS”. THE BUS IS CONTROLLED BY THE BODY CONTROLLER. DOUBLE CHECK ALL FUSES IN PDC (POWER DISTRABUTION CENTER) UNDER HOOD AND FUSE CENTER UNDER DASH.
How long does it take for no bus gauges to work?
After 15 minutes and all the dash panels have been removed for the second time (why didn’t I off load this the first time) it starts working again. But, What did I do??
Why does my Dodge truck have no gauges?
Fortunately when I finally broke down out of utter frustration and took it to the dealer to have it repaired the first time it didn’t cost me an arm. $108 later the service guy said it was a loose wire connection in the PDC.
What kind of truck has no bus gauges?
I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type. My Story… See the end to get straight to my find. I’ve had my gauges go out with the “no bus’ message in the odometer window three times now!