What does FMI 14 mean on a Volvo?
FMI 14 The code informs you that the electric fuel pump has been turned on. Not a malfunction code. FMI 1 Low engine oil level, level sensor faulty. FMI 4 The voltage at the contacts of the engine block EV15-EB22 is lower than 0.5 V. A short to negative or to a signal wire. The level sensor may be faulty.
What is the fault code for a Volvo mid128?
Check the integrity of the data channel wiring. FMI 11 Missing or invalid speed signal transmitted via SAE J1939 data channel, speed sensor faulty, SAE J1939 data channel faulty, vehicle control unit faulty (VECU). The speed signal is transmitted via the SAE J1708 data channel. If FMI 9 is present, the engine speed does not exceed 1700 rpm.
What is the fault code for a mid 128 engine?
Engine ECU Faults (MID 128) Fault Code Description FMI Codes MID 128 PID 26 Engine Fan Speed Percent 3,8 MID 128 PID 27 EGR Valve #1 Position Sensor 3,4,5 MID 128 PID 45 Preheater Relay Status 3,4,5 MID 128 PID 81 Particulate Filter 0,2,3,5,12
What is the fault code for a Volvo D16b?
For engine D16B: The fuel pressure is above normal (more than 700 kPa). The fuel filter is clogged, the bypass valve does not open. FMI 3 The voltage on the EA27 contact of the engine block is above 4.95 V. Short circuit of the wire to the power supply or to the signal wire.
What is FMI 11 missing or invalid speed signal?
FMI 11 Missing or invalid speed signal transmitted via SAE J1939 data channel, speed sensor faulty, SAE J1939 data channel faulty, vehicle control unit faulty (VECU). The speed signal is transmitted via the SAE J1708 data channel.
What are theproducts of the 2010emissions servicemanual truck?
Theproductsareundercontinuousdevelopment.Vehiclesandcomponentsproducedafterthe abovedatemaythereforehavedifferentspecificationsandrepairmethods.Whenthisisbelieved tohaveasignificantbearingonthismanual,supplementaryservicebulletinswillbeissuedtocover thechanges. Theneweditionofthismanualwillupdatethechanges.
What does FMI 4 mean on a climate control unit?
FMI 4 The climate control unit registers a signal with a voltage below 0.3 V from a pressure sensor. The signal wire is shorted to ground, there is a wire break between the unit and the sensor, or the sensor is not connected to the connector.
What is the diagnostic code for FMI failure?
FMI FailureModeIdentifier: Identificationoffaulttypes. 2 Group28 EngineControlModule(ECM)DiagnosticTrouble Codes(DTCs) SAEJ1939FMITable