What does fiber optic cable do for Mercedes Benz?
The fiber optic cables are used to transmit the sound signal of your Mercedes-Benz between the different units for better sound quality and faster transfer rates. When one of your components goes down, your COMAND will stop functioning.
What kind of radio does a Mercedes Benz use?
The kit works with radios from Pioneer, Kenwood, JVC and others. The interface works on the M.O.S.T. fiber optic system used by many Mercedes-Benz Command Radiosystems. Typically if you were to remove a factory Mercedes radio to add an aftermarket radio you would also need to replace the speakers and amplifier.
How to install a stereo in a Mercedes?
Mercedes Car Radio Stereo Audio Wiring Diagram Autoradio connector wire installation schematic schema esquema de conexiones stecker konektor connecteur cable shema car stereo harness wire speaker pinout connectors power how to install. Mercedes Car radio wiring diagrams. Car radio wire diagram stereo wiring diagram gm radio wiring diagram.
Can a subwoofer be installed in a Mercedes Benz?
The output from all speakers including subwoofer and premium sound quality. This makes for a nice clean easy install. When installing this interface into your Mercedes-Benz/Porsche/BMW you must make sure that the fiber optic signal loop is not broken.
Which is Avin fiber optic AMP interface does Mercedes-Benz use?
The MOST-MLGLR supports any aftermarket radio and the following Mercedes-Benz model years: The AVIN MOST-MLGLR Fiber Optic Amp Interface allows the Mercedes Harmon Kardon factory amplifier, the output from all speakers including subwoofer, and premium sound quality to be retained when installing ANY aftermarket radio.
What does fiber optic cable look like on Mercedes Benz?
With the fiber optic loop, one component goes bad, you have no audio. The fiber optic cable looks like two orange wires that connect to each piece of equipment in the loop. Do not bend, crimp or cut the fiber optic cable. Mercedes Benz Fiber Optic Bypass Coupler Part Number 000-545-33-84 Available from the dealership
The kit works with radios from Pioneer, Kenwood, JVC and others. The interface works on the M.O.S.T. fiber optic system used by many Mercedes-Benz Command Radiosystems. Typically if you were to remove a factory Mercedes radio to add an aftermarket radio you would also need to replace the speakers and amplifier.
How to troubleshoot a Mercedes Benz car stereo?
Mercedes SL NOTE- When troubleshooting, check fiber optic cable for damage near hinge and piston for center console at front of voice control module. About Us|BOSERepair| FAQ| Shipping| Top 10|Car Stereo Repair Home|Car Stereo Removal