What do you use to loosen throttle cables?
Use wrenches on the adjusters to loosen the throttle cables. The adjusters look like steel nuts around the cables. Back the screws all the way out. The switch housing looks like a black box on the handlebar. Use a socket wrench with the appropriate bit to unscrew the bolt located underneath the switch housing.
How to change the accelerator on a CX500?
Loosen the throttle valve is closed. Measure the clearanc pump rod and the throttle valve closed. between the accelerator adjusting arm with the L PUMP ACCELERATOR UMP C V *500 Assemble the acceler order of disassembly. Remove the diaphragm. Inspect the diaphragm for cracks al tieness. Replace if necessary. Be sure the accelerator rod is not bent.
How do you adjust the throttle cable on an outboard?
Step 1 Loosen the throttle cable adjuster jam-nut with the wrenches. Push the control lever forward to the “Forward idle” position. Pull the control lever back, through neutral, into the reverse idle position. Push the throttle to the “Full forward” position. Adjust the gearbox control cable. Push the control to the “Forward idle” position.
How do you put throttle control on a car?
Grasp the control cable and place it under the cable clamp. Pull until the cable is taut, then tighten the clamp screw. NOTE: The engine control lever should be against the high idle RPM stop bracket. 6. Move the application throttle control to the slow position, then to fast.
How do you loosen throttle cables on a motorcycle?
First, put the motorcycle onto a lift so that it stands flat on the ground. Completing this step is important for viewing and safety purposes. Use wrenches on the adjusters to loosen the throttle cables. The adjusters look like steel nuts around the cables. Back the screws all the way out.
What should the tension be on the throttle cable?
The accelerator cable tension is usually set so that 2-3mm of free play is present in the throttle grip. Once the correct tension has been applied, the lock nuts should be snugged and any dust covers should be slid back over the adjusters.
How can I tell if my throttle cable is binding?
With the engine idling and in neutral, rotate the handlebars from stop to stop and listen for any changes in idle behavior. Increases or decreases in idle speed may suggest that the throttle cable is binding either due to tight spots or cable routing. ProX has throttle cables available for a long list of applications.
How to adjust the clearance on a CX500?
CLEARANCE: 0.1—0.3 mm (0.004-0.012 in) Adjust by bending the adjusting arm. Loosen the throttle valve is closed. Measure the clearanc pump rod and the throttle valve closed. between the accelerator adjusting arm with the L PUMP ACCELERATOR UMP C V *500 Assemble the acceler order of disassembly. Remove the diaphragm.