What do you do when your 4 wheeler wont start?
If your ATV doesn’t crank at all when you’re trying to start it, there are a few basic things to look into.
- Make sure the kill switch/run switch is in the “ON” or “RUN” position.
- Make sure the ATV is in “Park” or Neutral.
- Make sure the battery is charged.
- Check the main fuse.
- Make sure the solenoid is getting power.
How do you check a spark on a ATV?
To quickly tell if your ATV is getting spark, remove the spark plug from the engine. Reinsert the plug back into the coil wire. Hold the electrodes of the spark plug close to the engine to ground it, and try starting the engine. If you see spark coming from the end of the spark plug, your ATV engine is getting spark.
Why does my ATV engine not start up?
This one’s real simple to check, but also one of the most important. If your engine isn’t getting enough air to mix with the fuel in the combustion chamber, it won’t run properly and might not even start up. Make sure the air filter is cleaned out, and there are no obstructions blocking the air box intake.
What should the voltage be on an ATV battery to start it?
The battery should read 12,6 – 12,8V. Use a multimeter or a voltmeter to check the voltage. If the voltage drops too low, the battery won’t have enough charge to start the bike. Charge the battery or replace it if it’s dead.
What should I do if my bike wont start?
Charge the battery or replace it if it’s dead. Am easy way to test your battery is by checking the voltage-drop with a multimeter as you try starting the bike. If your fully charged battery drops below 11,5 volts under load (while you crank the starter), it needs to be replaced.
Why does my quad bike not start up?
Having gas just as old as 6 months or so can start to cause corrosion in your fuel system. Make sure if you’re going to let the quad sit for a while that you drain the gas out and start with new gas next time you start it up.