What do I need to know about torque specs?
This answer was rated: I need the torque specs and procedure for changing the gaskets and seal on the… I need the torque specs and procedure for changing thegaskets and seal on the front gear housing for a Cummins ISX with a single cam.
How to get the torque specs for a Cummins?
Diesel Technician Vocational, Technical or Trade School 17 satisfied customers Got a front cover leaking oil pretty bad on a 2013 389 Pete Got a front cover leaking oil pretty bad on a 2013 389 Pete with isx cummins looking to see what is all needed and torque specs on all that… read more cumminsdr Mechanic High School or GED
How much torque does a drill collar connection make up?
Drill Collar Connection Make Up Torque OD Size Type in 1 1 1/4 1 1/2 1 3/4 2 2 1/4 2 1/2 2 13/16
I need the perkins torque spec for – Head bolts, Rod caps, Valve clearance gap, water pump bolt torque spec, We are putting the head back on – The rod to piston bearing is being replaced. The motor nu … read more I have a 2004 JCB 535 FS Loadall.
How are rocker arms installed on an M11 engine?
The rocker lever assemblies must be installed in the engine so they are in same position as they were removed from. Install the assemblies on the engine. Hand tighten the mounting capscrews at this time. The rocker lever side clearance must be adjusted before the capscrews are tightened to their final torque value.
Where do I find the torque on my M11 engine?
Push or use a hammer to tap the number one support toward the rear of the engine. Tighten the Number 1, 2, 3, and 4 support capscrews to their final torque. Check the front and rear assemblies for correct clearance. Check the support capscrews for the correct torque value. Here is injector torque. Install the injector hold down clamp capscrew.
What are torque specs for 3034 cat engine?
NEED TORQUE SPECS FOR 3034 CAT/PERKINS ENGINE ON 262 CAT SKID STEER. SPECS FOR CONNECTING RODS, … read more Vocational, Technical or Tra… Vocational, Technical or Tra… what are the torque specs for the rockers and what are the tolerances for intake,exhaust and injector.