What do I need to install throttle cable?
If the cable housing is black universal or Vintage Series, remove the ferrule. Measure the distance between the throttle cable adjuster and the firewall fitting. Add 2″ to the measurement and mark the cable housing at that length. NOTE:The cable housing must notbe straight between the throttle cable adjuster and the firewall.
How do you install throttle cable on Lokar?
The Lokar Throttle Cable is designed to be cut-to-fit. Step 1: Install the Lokar Throttle Pedal and Cable Mounting Bracket first, following the instructions that are provided with those parts. Step 2: The hole in the firewall must line up with the hole in the upper arm on the Throttle Pedal. Determine exactly where the Throttle Cable
What kind of pliers do you use to cut throttle cable?
If the Throttle Cable has the black universal or Vintage Series housing, cut the cable housing at your mark with heavy duty 8″ diagonal cutting pliers or a hacksaw. Lokar recommends Klein brand Diagonal Cutting Pliers, # D2000-28 available at The Home Depot or through W. W. Graingers, part # 4A838.
What’s the difference between a kickdown and a throttle cable?
They are designed with a specially extruded liner for extended life of the cable – not to be confused with ordinary brake hose. Kickdown features aluminum fittings with ferrule to eliminate frayed cable ends.
Where is the throttle cable in a car?
Position the application throttle control in the fast throttle position. Then move the throttle control back 3/16″ (4.75 mm). Insert the control cable bowden wire in the proper hole of the engine control lever, which is located on the side of the carburetor air intake elbow.
How do you put throttle control on a car?
Grasp the control cable and place it under the cable clamp. Pull until the cable is taut, then tighten the clamp screw. NOTE: The engine control lever should be against the high idle RPM stop bracket. 6. Move the application throttle control to the slow position, then to fast.
The Lokar Throttle Cable is designed to be cut-to-fit. Step 1: Install the Lokar Throttle Pedal and Cable Mounting Bracket first, following the instructions that are provided with those parts. Step 2: The hole in the firewall must line up with the hole in the upper arm on the Throttle Pedal. Determine exactly where the Throttle Cable
How to fitting throttle cable to Amal concentric?
To the Right is an example of Top: Ferrule Vs Bottom: Stepped ferrule (top hat) Start out by removing the cable from the throttle to give yourself more working length. Fig 2: Install the throttle spring and use the slide to compress the spring.
If the cable housing is black universal or Vintage Series, remove the ferrule. Measure the distance between the throttle cable adjuster and the firewall fitting. Add 2″ to the measurement and mark the cable housing at that length. NOTE:The cable housing must notbe straight between the throttle cable adjuster and the firewall.
How do you adjust the throttle on a motorcycle?
Once the decelerator cable has been set, the accelerator cable is adjusted. The accelerator cable tension is usually set so that 2-3mm of free play is present in the throttle grip. Once the correct tension has been applied, the lock nuts should be snugged and any dust covers should be slid back over the adjusters.
Where are the adjustment points on the throttle cable?
Some applications have adjustment points at the throttle body or carburetor and at the throttle cable housing, while others have a single adjustment point on the throttle cable housing.
How do you remove throttle cable from carburetor?
On single cable carbureted applications featuring round or oval slide carburetors, unscrew the top cap of the carburetor where the throttle cable enters the slide. Compress the return spring and carefully remove any necessary hardware securing the cable end to the slide.