What causes a p0208 engine light code?
The causes of a P0208 engine light code could be any of the following: Bad injector. This is usually the cause of this code but doesn’t rule out the possibility of one of the other causes. Open in the wiring to the injector. Short in the wiring to the injector.
What does p0208 mean on a PCM?
P0208 means that the PCM detected a fault in the injector or the wiring to the injector. It monitors the injector and when the injector is activated, the PCM expects to see the voltage pulled “low” or close to zero.
Can a PCM intermittent condition be performed on a fuel injector?
Yes, go to step 2. No, perform the PCM intermittent condition. Step 2. Fuel injector wiring and connector inspection Turn the ignition off, verify that the connector is properly connected to the injector. Disconnect the fuel injector harness connector and inspect the wiring and terminals for any condition that would result in a poor conenction.
What is the p0201 code for cylinder 1?
P0201 code definition. P0201 is referencing a generic issue in the injector circuit in cylinder 1. Note: This code is similar to P0200, P0202, P0203, P0204, P0205, P0206, P0207, P0208. In addition, this code may be seen with engine misfire, rich, and lean conditions.
Is it safe to drive a car with p0206 code?
P0206 can cause some concern depending on the symptoms displayed. Care should be taken with driving a car with P0206 and if the engine runs poorly, or has trouble staying running, it should not be driven. Repairs should be made ASAP to get the vehicle back onto the road and operating as designed. What repairs can fix the P0206 code?
What does the p0206 code on the ECM mean?
What the P0206 code means. When a P0206 code is seen, the Engine Control Module (ECM) has detected either voltage or resistance that is out of specification in the fuel injector circuit for cylinder 6.
Are there any common mistakes in diagnosing p0201?
Common mistakes when diagnosing the P0201 code. Mistakes can be made performing diagnosis of any code if proper steps are not followed or are skipped. Though the most common cause of P0201 is the cylinder 1 fuel injector, it must be properly tested to ensure it is at fault.