What causes a Mercedes Benz Distronic Plus to malfunction?
The most common problems that cause the Distronic Plus to malfunction include: The system has not detected any other vehicles on the road for a very long period. To find out what is wrong with your Distronic Plus, you will need to read the fault codes from that module.
What is a fault and what are the different types?
What is a fault and what are the different types? A fault is a fracture or zone of fractures between two blocks of rock. Faults allow the blocks to move relative to each other. This movement may occur rapidly, in the form of an earthquake – or may occur slowly, in the form of creep .
What does the Distronic Plus inoperative message mean?
When there’s a problem with your Distronic Plus system, you’ll be alerted to the error by a message on your dashboard which reads, “Distronic Plus inoperative”.
What kind of fault moves along the dip plane?
Faults which move along the direction of the dip plane are dip-slip faults and described as either normal or reverse ( thrust ), depending on their motion. Faults which move horizontally are known as strike-slip faults and are classified as either right-lateral or left-lateral .
What are the different types of electrical faults?
Three phase fault analysis or information is required for selecting set-phase relays, rupturing capacity of the circuit breakers and rating of the protective switchgear. These are very common and less severe than symmetrical faults. There are mainly three types namely line to ground (L-G), line to line (L-L) and double line to ground (LL-G) faults.
The most common problems that cause the Distronic Plus to malfunction include: The system has not detected any other vehicles on the road for a very long period. To find out what is wrong with your Distronic Plus, you will need to read the fault codes from that module.
What are the different types of fault limiting devices?
Some of these fault limiting devices include fuses, circuit breakers, relays, etc. and are discussed below. • Fuse: It is the primary protecting device. It is a thin wire enclosed in a casing or glass which connects two metal parts. This wire melts when excessive current flows in circuit.
How often do symmetrical faults occur in electrical power systems?
Only 2-5 percent of system faults are symmetrical faults. If these faults occur, system remains balanced but results in severe damage to the electrical power system equipments. Above figure shows two types of three phase symmetrical faults. Analysis of these fault is easy and usually carried by per phase basis.