What causes a flex plate to go bad?
The following causes for cracked flexplate failures: 1) Out of balance engine or torque converter. 2) Bad starter drive can cause teeth or ring gear to wear rapidly or break off. Teeth can also break when engine is running and starter is engaged. 4) Some applications may require starter shims to be used.
Can you reuse flexplate?
Its ok to reuse them, just put a little loctite on them when reinstalling.
Can you install a flexplate backwards?
Yes it can go in backwards. Pull your inspection cover off and see if the converter lugs are in the recess of the flexplate.
Can torque converter bolts be reused?
I reuse factory torque converter bolts on a daily basis without any issues. I do agree with what was said before that most likely your factory converter bolts are bottoming out on the tips before the head gets a good seat which is probably the root cause of the issue.
Can you reuse flywheel bolts?
Flywheel bolts are reusable as long as they are in good condition. Clean them off, apply red loctite. Good as news and you wont have to spend an extra 60 on new ones.
How much does it cost to fix a flex plate?
How much is a replacement flex plate? The flex plate or flywheel plate should cost somewhere in the region of $50-160, on average.
What happens if you put a flexplate on backwards?
Putting it in backwards will effectively move the ring gear of the flexplate aft – and by the witness marks on the ring gear from the starter, it would appear that’s the case becuase it looks like it’s only partially engaging on the forward edges of the teeth – assuming the starter solenoid is pushing the starter gear …
What happens if you install a flywheel backwards?
Usually when a flexplate is installed backwards, the coverter will hit the face of the flexplate and not allow the convertor to bolt up ( to much space between the convertor tab and flexplate).
Can a bad flex plate be replaced with a new one?
A bad flex plate usually has failed due to either damage or wear and tear, so replacement with a new flex plate is the only solution. Because the flex plate is an integral part of your car’s powertrain, and replacing it involves removing the transmission, a significant amount of labor will be involved.
How does the flex plate work in a car?
After the engine produces mass-energy, the flex plate or the flywheel initiate their job and start storing the energy produced. This is executed by the spinning of the plate at a high pace and an even speed. The next step entails the transfer of this piled-up energy to the transmission box.
Where does the torque converter go on the flex plate?
The flex plate is a stamped metal disk that mounts the torque converter to the rear of the engine’s crankshaft.
Can a cracked flex plate cause transmission problems?
A cracked flex plate is almost always, a sign of other problems. So, if not properly diagnosed, it will occur again and often damage to the transmission may follow. The same things that caused the flexplate to crack, can also cause transmission problems.
https://www.youtube.com/watch?v=xDrzDa0BvQg