What causes a 350 Turbo transmission to shift?
Also check the planetary pinions, the sun gear, and both the front and rear internal gears for tooth damage. Finally, check the condition of the engine’s two motor mounts. If one or both of the motor mounts are damaged, the engine will cause the transmission to shift, which will in turn cause the transmission to produce noise.
Is the GM Turbo 350 a good transmission?
The Turbo 350 was known as a durable transmission and was used extensively by GM. However, over time the Turbo 350 will develop problems, as with any type of transmission, but troubleshooting this transmission is easier than many other types due to its basic design.
Where do you find the gears on a turbo350?
Find them on Amazon.com or with Google. other things sometimes lost during the process!) pointing towards the rear of the vehicle. turn the screw in / to the right. in the lower gears for a few extra miles per hour. fluid be sucked up into the intake manifold. there was no leaking on to the ground.
When to remove the valve body on a GM Turbo 350?
The most difficult problems when it comes to transmission function involve the valve body (control valve assembly). In almost all cases the valve body must be removed to correct any issues, and this should be done after all other possibilities have been eliminated.
Also check the planetary pinions, the sun gear, and both the front and rear internal gears for tooth damage. Finally, check the condition of the engine’s two motor mounts. If one or both of the motor mounts are damaged, the engine will cause the transmission to shift, which will in turn cause the transmission to produce noise.
The Turbo 350 was known as a durable transmission and was used extensively by GM. However, over time the Turbo 350 will develop problems, as with any type of transmission, but troubleshooting this transmission is easier than many other types due to its basic design.
Is the TH350 transmission easy to troubleshoot?
The TH350 is a rugged and durable unit, and fairly simple in construction and operation as far as automatic transmissions are concerned. If you have correctly assembled the unit, and it passed the air checks to the clutch drums through the openings in the case during assembly, any issues should be relatively easy to diagnose and repair.
What causes a noisy transmission in a GM Turbo 350?
Noisy Transmission Noise from pump caused by high or low oil level Cavitation from plugged oil filter Water in oil Damaged oil pump gears and housing Worn or damaged planetary gears Burnt or worn clutch plates, or burnt lining on band