What are the trouble codes for a Land Rover?
Hello everyone i have a problem with my car it starts idle and gets into gear but when i accelerate it doesn’t move forward even reverse I’m getting these codes U2023 and P2733 i did get to know about P2733 but now I’m confused about the second code… I�ve got a 2011 LR4 with both P0171 and 00174 codes.
What is the Check Engine Light code for a 2011 LR4?
I�ve got a 2011 LR4 with both P0171 and 00174 codes. Intake manifold pressure is a steady 9.2 inHg and from what I gather it should be 15-20. Both upstream O2 sensors are both at .000 volts but they should be fluctuating between .1v and .9v.
How can I Test my Land Rover battery?
Start the engine and run it at about 3000 rpm with all electrical accessories turned off. Set the voltmeter to the DCV scale and measure the voltage between the positive and negative terminals of the battery. Make sure that the tester is connected to clean areas of the terminals.
How are connectors identified in Land Rover LR2?
Connectors Connectors and header joints are identified by their corresponding connector number with a numbered suffix to indicate the pinout detail of the wire, i.e. C0292-1 identifies connector 292, pin number 1. Wire insulation colours are listed in a table at the end of this section.
Hello everyone i have a problem with my car it starts idle and gets into gear but when i accelerate it doesn’t move forward even reverse I’m getting these codes U2023 and P2733 i did get to know about P2733 but now I’m confused about the second code… I�ve got a 2011 LR4 with both P0171 and 00174 codes.
I�ve got a 2011 LR4 with both P0171 and 00174 codes. Intake manifold pressure is a steady 9.2 inHg and from what I gather it should be 15-20. Both upstream O2 sensors are both at .000 volts but they should be fluctuating between .1v and .9v.
Where are the oxygen sensors located on a Land Rover?
All information regarding DTC’s for this model is contained within the Land Rover TestBook Diagnostic Unit. The manufacturer does not provide any other information on pulling codes, descriptions, diagnosis, clear codes, etc. *Codes* are used to identify the 4 Oxygen Sensors. A = Bank A of the engine. Cylinder #1 is located on Engine Bank A.
When does an OBD-II fault occur in a Land Rover?
When an OBD-II fault occurs in Land Rover’s Generic Engine Management System (GEMS), the Malfunction Indicator Lamp (MIL) is illuminated.