What are the mounting bolts on a Chevy Blazer?
•Mounting bolts. Torque the left bolt to 22 ft. lbs. (30 Nm) and the right bolt to 32 ft. lbs. (43 Nm). •Wires. Torque the battery feed wire nut to 71 inch lbs. (8 Nm). •Alternator brace. Torque the nuts and bolts to 22 ft. lbs. (30 Nm). •Accessory belt •Negative battery cable 4.3L Engine Install or connect the following:
How do you replace power steering in a Chevy Silverado?
Reconnect the negative (black) battery terminal. Use a funnel to direct the power steering fluid into the pump, and pour until the fluid reaches the fill line. To make sure the power steering fluid is circulating throughout the entire system, turn on the engine and rotate the steering wheel left as well as right multiple times.
How do you replace a / C belt tensioner on a Chevy Silverado?
Rotate the tensioner clockwise against the spring, and hold it. Then slip the belt off the tensioner pulley. Release the tensioner slowly back to the spring stop. Slip the belt off the crank pulley and let it hang. Figure 4. Accessory drive belt removal. Examine the belt for cracked ribs or fraying, and consider replacing it.
How do you install an accessory drive belt on a Chevy Silverado?
Install accessory drive belt. Connect the intake duct bracket to the clip on the upper radiator hose. Slide the duct over the MAF sensor as well as the intake manifold fittings, and tighten the clamps. Remove the electrical tape from the negative battery terminal, and reconnect the negative lead.
Reconnect the negative (black) battery terminal. Use a funnel to direct the power steering fluid into the pump, and pour until the fluid reaches the fill line. To make sure the power steering fluid is circulating throughout the entire system, turn on the engine and rotate the steering wheel left as well as right multiple times.
What kind of power steering bracket do I Need?
FOR POWER STEERING BRACKET THAT HAS NO SLOTTED ADJUSTMENT IN THE BRACKET ITSELF. Type-3 w/adjustment slot. Driver-side mount/long water pump. (Glass beaded & repainted semi-flat black.) FOR POWER STEERING BRACKET THAT HAS SLOTTED ADJUSTMENT IN THE MOUNT ITSELF. Type-2 without adjustment slot. Same as type-3 only without a slot.
Where are the intake gaskets on a Chevy Vortec?
The intake gaskets on the LB4 and L35 vortec’s are very prone to going bad which results in engine leaks, overheating, stalling, etc. The intake gasket sits between the intake manifold and the cylinder head.
What causes a Chevy Vortec distributor to not turn?
The cap is prone to warping from the heat, which results in the cap rubbing against the distributor rotor button. This causes the rotor bushing to wear out and the distributor begins to no longer be able to turn. The simplest option here to fix this problem is upgrading to a distributor that has an aluminum housing on it.