What are the fuses on a ford 750?
Ford F-750 (2004 – 2010) – fuse box diagram Year of production: 2004, 2005, 2006, 2007, 2008, 2009, 2010 Engine Compartment Fuse Box Number Ampere rating [A] Description F1 15 Main light switch F2 30 Power seat (driver) F3 30 Power seat (passenger) F4 15 Washer pump relay, Washer pump motor F5 15 Caterpillar / Cummins: Brake …
Why is my Fuse not working on my Ford F150?
If electrical parts in your vehicle are not working, the system may have been overloaded and blown a fuse or tripped a circuit breaker. Before you replace or repair any electrical parts, check the appropriate fuses or circuit breakers.
Where is the fuse located on a Ford F650?
Vehicles with Allison transmission equipped vehicles have a 10 Amp fuse located in the clean power cables located in the battery box. All vehicles have a 30 Amp fuse located in the clean power cables located in the battery box.
How do you know if you need to replace a fuse?
To check a fuse, look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse. Before replacing fuses check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.
What are the problems with a Cummins 5.9 engine?
Despite the reliability of the Cummins 5.9, its fuel system is its Achilles heel. As discussed above, the fuel injectors are responsible for spraying highly pressurized fuel into the engines cylinders. With the 5.9’s fuel pumps flowing north of 25,000psi, the injectors face a significant amount of stress.
Is the Cummins 6.7L engine still in production?
The engine continued in production until 2007 when it was retired for the 6.7L Cummins, primarily due to increased emissions regulations. The Cummins diesel engine is unique in the diesel truck world, as it is uses an inline design and only features 6 cylinders.
When did the Cummins 5.9L B series come out?
The Cummins 5.9L “B-Series” diesel engine was produced from 1984 up until 2007. First generation versions were named the 6BT but also commonly referred to as the 12v, or 12-valve. Each cylinder had 2 valves, hence the name 12-valve. Midway through 1998, the 6BT was replaced with the ISB, which stands for “Interact System B”.
Why do I need to Reset my ECM?
If your check engine light comes on then chances are there may be an internal electrical issue within your vehicle that must be addressed. Before replacing any parts you want to reset your ECM to ensure that part replacements are absolutely necessary. There are a few ways to reset your Engine control modules.
When was the Caterpillar C7 diesel engine made?
The Caterpillar C7 Engine was produced from 2003 – 2009 and was originally touted to be the greatest CAT Engine ever made. However, things don’t always go according to plan. Read about the history and technical specs of this legacy engine. Looking for remanufactured diesel engine parts?
How long should I Leave my ECM at idle?
You will want to leave your vehicle at idle for at least 10 minutes which will give your ECM enough time to “learn” any new modifications installed on your vehicle.