Is there check engine light on Jeep Grand Cherokee?
There is no check engine light at all. On the screen inside the car, it is not saying anything. Sometimes it will say like if you have a problem – it used to say that we have a coolant sensor bad or things like that. We are very very confused as to why this is happening.
Why does my Jeep Grand Cherokee not start?
For 1996+ Jeeps, the OBD-II engine computer (ECU/PCM) re- boots, and the idle settings are deleted, when you: (1) let the battery run down by leaving the lights or radio on, (2) disconnect the battery for an extended period of time, (3) or when the battery goes bad and needs replacing.
Why is the alternator on my Jeep not charging?
Looks like the field coil of the alternator isn’t getting power. There are 3 wires attached to the alternator. One is a big fat wire that goes to the battery, this is the alternator output. The other two wires feed power to the field coil.
What is the OD on a Jeep Grand Cherokee?
The OD inputs are overdrive off switch, TPS, VSS, transmission temp sensor, output speed sensor and engine rpm. The torque converter clutch (TCC) solenoid will normally operate in overdrive, but the TCM can operate the TCC in third gear if the overdrive off switch is selected.
Why does the battery light come on on my Jeep Cherokee?
If your Jeep Cherokee’s battery light is on, it means a few things. It is trying to warn you that there is an issue with the charging system. The charging system itself is relatively simple. It’s almost always going to be caused by a bad battery or alternator. The battery light comes on when it detects that the voltage in the battery is too low.
What should I do if my Jeep Cherokee won’t start?
Start your jeep and let it run for 5 minutes. If the problem is a dead battery, then this will charge it. Do not start the car that has the live battery. Disconnect all cables in the opposite order that you connected them.
What should battery voltage be in Jeep Cherokee?
Touch the positive side of the voltmeter to the positive battery wire. With the engine off, you should get a reading somewhere between 12.0 volts and 12.6 volts. Now that you have a baseline, it’s time to turn the engine on. Leave the air conditioner off, as well as the headlights and any other accessories.
The OD inputs are overdrive off switch, TPS, VSS, transmission temp sensor, output speed sensor and engine rpm. The torque converter clutch (TCC) solenoid will normally operate in overdrive, but the TCM can operate the TCC in third gear if the overdrive off switch is selected.