Is there an electrical fault on my MaxxForce 7?
Electrical fault on a 2011 international maxxforce 7. 2011 international maxxforce 7. We replaced the entire short block Have truck repair questions? Ask an Expert By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them.
What makes a MaxxForce DT have no power?
I know if it is a epa10 and you block off the cross over tube on the back side of the engine it will cause the exhaust back pressure to go to high into like 60 psi or so and the engine will cut back fuel to the injectors. Making low boost and no power. 6 03-19-2019, 06:14 PM (This post was last modified: 03-19-2019, 06:16 PM by kuracnabiciklu .)
What is fuel pressure on international 4300 MaxxForce 466?
I have a 2011 International 4300 Maxxforce 466. Just did a PM service, now a hard start when code .need to starting fluid to initially get it running. Code pops up, SPN 931 FMI 11. I check fuel pressure on the computer, 74 psi.
How to check harness resistance on MaxxForce 466?
30 to GND B+ If 0 volts, check power circuit to relay switch for OPEN or short to GND, or blown fuse. If < B+, check for failed circuitry between batteries and relay. Go to Harness Resistance Check. 85 to GND 0 to 2 V If > 2 volts, check EFP control circuit for OPEN or short to PWR. Go to Harness Resistance Check.
Is there service kit for MaxxForce diesel engine?
A service kit is available for the MaxxForce DT diesel engines that allows mechanics to disassemble the low pressure and high pressure turbocharger on the compressor side (intake) and remove the soot buildup.
Why does my Maxxforce Engine have a low power tip?
The main cause of this is a plugged up engine crankcase breather. A service kit is available for the MaxxForce DT diesel engines that allows mechanics to disassemble the low pressure and high pressure turbocharger on the compressor side (intake) and remove the soot buildup.