Is there a way to fix a leaking Fork seal?
Seal Mate has been fixing leaking fork seals on all types of dirt bikes and street bikes for over two decades. Many motorcycle shops charge hundreds to replace your fork seals. With this simple and easy to use tool you can fix your leaking fork seals for a fraction of the price!
How do you replace a fork seal in RevZilla?
RevZilla photo. It’s easy to do. Cut off a chunk of 35mm film. Pop your dust boot up. Gently slide the film between the seal and the fork tube. Work it around the seal, up and down, until you get back to where you started.
How long does it take to replace Fork seal on dirt bike?
Now pull out your handy fork-seal driver and wrap it around the fork leg. Drive the seal into place with three or four firm strikes. You’ll feel the seal hit bottom. Time: 20 minutes. Replace the seal retainer and the dust seal. Now you can tighten things up.
Where is the seal on a steel fork?
Pry off the ring-shaped rubber dust seal and semicircular metal C-clip at the center of the fork leg with the tip of a screwdriver. Then, give the 2 halves of the fork a sharp tug to separate them. Removing the slider piece will expose the fork seal, which sits near the bottom of the stanchion.
Seal Mate has been fixing leaking fork seals on all types of dirt bikes and street bikes for over two decades. Many motorcycle shops charge hundreds to replace your fork seals. With this simple and easy to use tool you can fix your leaking fork seals for a fraction of the price!
How to replace a fork seal with seal mate?
Seal Mate Is Simple Anyone Can Do It! 1 Step 1) Remove Dust Seal Pry down the dust seal and clean the fork tube to make sure no debris gets pushed into the oil… 2 Step 2) Insert Seal Mate & Rotate Gently insert the Seal Mate tool into the fork to push it past the oil seal typically… 3 Step 3) Replace Dust Seal More
RevZilla photo. It’s easy to do. Cut off a chunk of 35mm film. Pop your dust boot up. Gently slide the film between the seal and the fork tube. Work it around the seal, up and down, until you get back to where you started.
How to remove dust seal from fork leg?
1 Wedge the dust seal from the fork leg. 2 Find the fork seal itself. It is held into place by a clip within a groove. 3 Pry the seal out carefully. 4 Flush the area as you go to remove debris within the fork. 5 Take the tube in 1 hand and the stanchion in the other. Use muscle to pull the 2 apart.