Is there a recall on 2013 Chevy Impala?
2013 Chevrolet Impala Recalls There have been 1 safety recalls issued from NHTSA. Summary: This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key.
What does an actuator do in a Chevy Impala?
What is a blend door actuator? In a vehicle’s heating and cooling system, the blend door actuators help control the air temperature from the vents, and direct air to selected vents.
Where is the PCV valve on a 2013 Chevy Impala?
The positive crankcase ventilation valve (PCV valve) on a Chevy Impala is generally located on the engine block. The exact location may vary from year to year; however, it is generally located on the valve cover. The end of the PCV valve looks like a rubber plug.
Why does my dashboard click?
The three most common causes of a clicking noise from the dashboard are: Heater control module lost calibration. Faulty blend door stepper motor.
Are 2013 Chevy Impalas good cars?
Probably the best car I’ve owned I’ve had this 2013 for six years now and drive about 70 miles each way to work on the highway. This car rides smooth, is quiet, has comfortable seats, gets great mileage, has more than enough power and has given me no problems for thousands of miles.
How many miles can a 2013 Chevy Impala last?
Given proper maintenance, a new Chevrolet Impala should last up to 150,000-200,000 miles.
What causes a bad connection on an Impala?
That in turn can cause a bad connection to open and close quickly. The computer senses that and turns the light on. The bad connection could be a chafed/broken wire in one of the harnesses to each hub, or it could be one of the connectors going bad at the ends of the harnesses.
How do I turn off traction control on my Impala?
Turning off traction control including stabilitrak in my 13, I don’t know if anyone mentioned it and I’ll assume its all the same, hold the T/C button for 3 seconds release when DIC says Traction or Stablitrak off. Each time the motor is killed you’d have to keep doing it.
How long does it take to repair a p0013 Chevy?
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P0013 CHEVROLET code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
What happens when you release the brake on an Impala?
When you release the brake, if there’s any play in the ball joints or tie rod ends (or strut mounts) the steering knuckle can move a bit causing the wires to flex slightly. That in turn can cause a bad connection to open and close quickly. The computer senses that and turns the light on.