Is the tach on a 2008 Harley Davidson?
My instructions are rev. 06-15-2004 and I’m afraid they aren’t current for the 2008 bike. The tach is not receiving the engine speed signal, but, the power is on. Problably has something to do with which # connection is the tach signal.
Where is the tach on a Harley Davidson Speedo?
As it turns out the #3 pin location is still the proper tach signal connection. It works perfect. Also, I mounted the tach with a special mount connected to the Chrome Dash above the Speedo….it looks great!
Why is the tach not receiving the engine speed signal?
The tach is not receiving the engine speed signal, but, the power is on. Problably has something to do with which # connection is the tach signal. Any thoughts?: Welcome to the site jw. I’m not the most technical one here but an obvious place to start is your ECM connection. Do you have the service manual?
Where is the tach connector on a Dyna harness?
I remember the unused connector position was the same on the Dyna harness and the V-Rod, so it seems probable it is generic, at least for some model years. As it turns out the #3 pin location is still the proper tach signal connection. It works perfect.
My instructions are rev. 06-15-2004 and I’m afraid they aren’t current for the 2008 bike. The tach is not receiving the engine speed signal, but, the power is on. Problably has something to do with which # connection is the tach signal.
What’s the 3wire on a Harley Davidson tach?
The tach harness that came from Harley was wired wrong and blew my abs module. The dealer techs scratched their heads to make the 3wire work with no success. I think the 3wire is for early models, the 7wire is for later models.
How to install a tachometer on a Harley Davidson?
Tachometer installation? Please can you guys help with this? It only came with 3 wires: Red (pos), Black (neg) & pink (signal?) I attach the positive to the lights fuse and the pink to the coil front cylinder, according to the service manual is the blue/orange cable all the way to the right:
The tach is not receiving the engine speed signal, but, the power is on. Problably has something to do with which # connection is the tach signal. Any thoughts?: Welcome to the site jw. I’m not the most technical one here but an obvious place to start is your ECM connection. Do you have the service manual?