How to turn on auxiliary idle control module?
Go to main programming mode, press and hold [RPM CONTROL], [CHARGE PROTECT] & [FORD] keys 2. In Menu 1, change the mode from “Base” to ” A CP ” with [ARROW] key. 3. Save and exit programming mode by pressing the [FORD] key. CHARGE PROTECT Page 5 Step 2 Activate Automatic Charge Protection Mode.
Where is the fuse box on a cruise control?
Locate the fuse box under the driver’s console. It has a plastic cover that can be removed . Check the inside diagram to determine which fuse you need to check. Probe both sides of the fuse. If one or neither lights the test light, the fuse is defected and replace.
Where is the engine control module located on a car?
Usually it is located either on the bottom of the radiator, or by follow the top radiator hose towards the engine block. You’ll see it on mounted on the engine block. It can be cleaned using a wire brush when you entirely change your engine coolant (approx. every 80,000 km or 50,000 miles).
How can I tell if my idle control valve is working?
To check if an idle control valve is working properly, start by turning on your engine and letting it run for a minute or 2. Then, when it’s at an idling speed, take note of the RPMs in your car. Next, turn the engine off and disconnect the idle control motor under your hood.
Locate the fuse box under the driver’s console. It has a plastic cover that can be removed . Check the inside diagram to determine which fuse you need to check. Probe both sides of the fuse. If one or neither lights the test light, the fuse is defected and replace.
How to troubleshoot a Ford Cruise Control System?
Check the cruise control module and combination stalk. These units rarely, if ever, fail. However, if the unit is bad, you’ll want to know. Remove the screws holding the steering wheel column cover in place and pull the cover off the steering column with your fingers.
How does a cruise control system work in a car?
Early systems used a vacuum motor and cable, but these eventually changed over to electric motors. Most recently, with the development of drive-by-wire or electronic throttle control systems (ETCS), cruise control is built into the engine control module (ECM), which controls the throttle body electronically.
How to reset the engine control module with no hassle?
Disconnect the battery and Switch the ignition key to the on position for about 15 minutes should reset the ECU Can a ECU be reset? Yes, all ECU (Engine Control units) can be reset and be should reset once per manufacturer’s guideline for a smooth relearn process or upon installing a replacement unit. How do I reset my Ford PCM?