How to stop intermittent stalling after starting a car?

How to stop intermittent stalling after starting a car?

There should be one terminal with power. If not, there is a bad wire under the fuse block to the battery; it should have constant power at one terminal. Take off the air cleaner and hold the throttle plate open with your hand. Spray some carburetor cleaner into the throttle body. Try to start the car for 2 seconds.

Why does my Jeep stall when I start the engine?

If it starts, the fuel pump is the problem. If not, the engine should be checked for spark. It could be a sensor or computer-related problem. To be absolutely sure, raise and support the back of the Jeep on jack stands, unless the height allows you to crawl under the back without raising it.

What should I do if my Schrader is stalling?

Take a small screwdriver and push in on the Schrader to see if fuel comes out in force. If not, hold the Schrader in and have the helper turn the key on. Be ready to release the Schrader if there is fuel pressure, for it will come out fairly steady. If there is no pressure, replace the cap and check the relay.

Why does my car stall when I start the car?

Engine stalling problems can be caused by, almost anything but, are usually sensor related. A cold engine needs a fairly rich fuel mixture to start, and to idle smoothly while it warms up. What do you look for when the car starts to shake and sputter eventually causing engine stalling.

What to do when your Harley starts stalling?

Start the bike cold. Mist the intake flanges with brake cleaner. If your bike’s idle drops, or the engine stalls, you have an intake leak. If this is the case, replace the intake seals along with the front & rear intake flanges. If the bike passes the intake test; have the dealer or your mechanic scan the m/c for possible codes.

What are the symptoms of an engine stall?

Here are some of the most common symptoms of, a faulty mass airflow (MAF) sensor; The engine is very hard to start or turn over. Engine stalling shortly after starting. The engine hesitates or drags while under load or idle. Hesitation and jerking during acceleration.

Can a stalling engine be intermittent driveability?

Intermittent driveability problems of any kind are always a challenge to diagnose. When a customer brings you a vehicle and complains of a stalling problem, you may not have much to go on other than their description of what’s happening and when it happens.

Posted In Q&A