How to Reset battery jaguar xf?
1 Switch off ignition. 2 Disconnect battery for 30 seconds reconnect battery (not required if battery changed). 3 Start the engine. 4 Confirm that the message “NOT CALIBRATED” or “APPLY FOOT AND PARK BRAKE” is displayed on the instrument cluster message centre.
How to program remote fob for Jaguar XK8 XKR?
Auto Reserve Jaguar – XK8 XKR Remote Fob Programming – Detailed Instructions: The procedure to program the remote fob or fobs is very simple and should take less than one minute. No tools are required. All remote fobs available must be present when the car is in programming mode, so that they can be programmed at the same time as the new fob.
How to reset the battery in a Jaguar?
8 Release the foot brake. 9 Confirm that the brake warning lamp is no longer illuminated on the instrument pack and that “NOT CALIBRATED” message is no longer displayed in the message centre. 10 apply and release the EPB 5 times to ensure no error is present.
How to reset the ecu-1 Jaguar car forum?
Restart the clock (where fitted) and set it to the correct time. Simultaneously press “>>” “PTY” “A.MEM” should only take 2 or 3 seconds and the radio turns on. 1. NOTE: After the battery has been disconnected it is necessary to
Is it OK to disconnect Jaguar XJ8 battery?
Don’t disconnect your XJ8 battery if you can help it. – Page 1 – Jaguar – PistonHeads UK Don’t disconnect your XJ8 battery if you can help it. It can cause various relays to “stick” open and subsequently drain the battery.
How long does it take to reset a Jaguar battery?
Allow the vehicle to idle for a further three minutes. Drive the vehicle at constant speeds of approximately 48 km/h (30 mph), 64 km/h (40 mph), 80 km/h (50 mph), 96 km/h (60 mph) and 112 km/h (70 mph) for three minutes each. This may cause a driveability concern if the procedure is not carried out.
How do you change battery on Jaguar XKR-XK?
TIP: you need to undo the bottom bracket being held by two 10 mm bolts and once you have that off you can remove the 2 nuts hold the bottom part of the battery at about 0:27 you can see the 2 nuts and on the left one of the 2 bolts to get the bottom bracket out. It is important to match up the proper numbers when replacing the battery.
How do you take a battery cable out of a Jaguar?
You remove the “-“ cable from the battery then take that cable and place it on the “+” cable and hold it in place for 30 seconds then place the “-“ cable back on the battery.
Auto Reserve Jaguar – XK8 XKR Remote Fob Programming – Detailed Instructions: The procedure to program the remote fob or fobs is very simple and should take less than one minute. No tools are required. All remote fobs available must be present when the car is in programming mode, so that they can be programmed at the same time as the new fob.