How to replace wheel hub and axle nut?
Install the rotor, then the brake caliper. Replace the two brake caliper bolts and tighten them to 85 ft/lb. Reinstall the wheel, lower the jack, and remove the jack stand. Repeat steps on the other side, and then test drive the car to ensure everything is working properly. Figure 7. Install new hub assembly and axle nut, tighten to 258 ft/lb.
How do you replace a front brake bracket?
Remove the bolts holding the caliper to the strut. There may also be a bolt holding the brake line bracket to the strut. Set the caliper on the control arm or hang it from the spring with a zip tie. The caliper set aside. Don’t let it hang from the brake line. Rob Siegel Next, pop off the dust cap with a screwdriver to expose the castellated nut.
How to replace wheel hub and brake line?
Turn the wheel to one side to gain the clearance necessary for the bar. Once the bolts are out, use a piece of wire or a wire hanger to hang the calipers in order to prevent damage to the brake lines. Pull the rotor off. If your rotor is rusty or stuck, hit each corner with a rubber mallet, turning the rotor 1/4 turn every time you strike it.
How to replace the wheel on a Ford Mustang GT?
Replace the two brake caliper bolts and tighten them to 85 ft/lb. Reinstall the wheel, lower the jack, and remove the jack stand. Repeat steps on the other side, and then test drive the car to ensure everything is working properly.
Install the rotor, then the brake caliper. Replace the two brake caliper bolts and tighten them to 85 ft/lb. Reinstall the wheel, lower the jack, and remove the jack stand. Repeat steps on the other side, and then test drive the car to ensure everything is working properly. Figure 7. Install new hub assembly and axle nut, tighten to 258 ft/lb.
How do you replace the wheel on a Ford Mustang?
Place your hands on the 12 and 6 positions, then shake the wheel back and forth. Excessive movement indicates that you have a bad wheel bearing or hub. If your Mustang exhibits these symptoms, keep reading and we’ll guide you through the process of replacing your wheel bearing and hub. Park the car on a flat surface.
How do you replace a wheel on a Honda Accord?
Slide the new wheel bearing assembly in place and replace the bearing bolts, then tighten them. Reinstall the center bolt on the hub. Slide the brake rotor back in place. Place the brake caliper back over the rotor and reinstall the brake caliper bolts. Reinstall the wheel as well as tire, and lower from the jack stands. Figure 8.
How do you replace a broken lug nut stud?
Use your fingers to pull the broken bolt from the rear of the hub flange. The replacement bolt was a stock part from a local auto parts supplier. To install the new bolt into the bolt hole, the wheel must be turned to align the hole with a slot on the rear of the hub flange, which provides the clearance to thread it through.