How to replace high intensity xenon headlight bulbs?
1. Xenon Bulb: http://amzn.to/2iXq7Lq 2. Screwdriver set: http://amzn.to/2jaHIfP 3. Ratchet and socket set: http://amzn.to/2inoxOY 4. Mechanic’s Tool Set: http://amzn.to/2Bzmccg 5. Disposable Gloves: http://amzn.to/2zSRuxO 6. Common Sense 7. Full HD Camera: http://amzn.to/2AvoEk7 8. My computer for editing / uploading: http://amzn.to/2i2sKYz 9.
How do you reverse polarity on HID headlights?
What this means is the power and ground wires of your vehicle’s stock harness are reversed. To reverse polarity on HID headlights, you must rotate the 2-pin oval connector on the HID ballast by 180 degrees in order to reverse the orientation of the plug.
What should I do if my HID light bulb is bad?
Swap the HID or LED bulbs to opposing sides. If the problem is reversed, you might have a bad bulb. This step will check if you have a bad bulb. To perform this test, please swap your bulbs to opposing sides and note what happens to your kit. If none of the above helps, please check for loose connections.
Where are the pins on the bi xenon HID kit?
Bi-Xenon HID kits have 3 pins on the harness connector for ground, low beam and high beam connections. You will need to release the pins inside the connector and reorder them. You may need several tries to find the proper orientation. Look inside the connector and with a precision screwdriver you can release the pins and reverse the wires. 3.
How do you replace a headlight bulb in a VW Passat?
Take the old bulb out of the socket and dispose of it immediately. Grip the new bulb by its plastic base and carefully insert it into the socket. Replace the weather seal, reinstall the air intake duct (if necessary) and turn on the headlights to make sure the new bulb works.
Where is the high beam bulb on a Passat?
Pull the rubber weather seal off of the low beam bulb socket. To access the high beam bulb socket, press down on the tab at the top of its plastic weather cover. Turn the bulb socket counterclockwise and pull it out of the headlight assembly.
How long does it take to replace a D1s headlight?
How to release the headlight to allow you plenty of room to replace the D1S headlight bulb, without taking the bumper off – this process takes about 30-45mins depending on how fast you work. CARE MUST BE TAKEN when releasing the light not to scratch your bumper etc.