How to replace engine water pump 02-13 Jeep Liberty?
Get any contaminants out of there. Take your new water pump and put the gasket into place. Now lower the water pump down into place and replace those eight 13mm bolts. Again, we’ll fast-forward as Don does this. Then you want to torque each of those bolts to 40 foot-pounds.
How do you remove a water pump belt?
If it is a serpentine belt, remove the belt by using a serpentine belt tool and turning the tensioner to relax the belt. If the vehicle has a v-belt, loosen the tensioner to relax the belt. Step 8: Remove the belt or belts from the pulleys.
How do you seal a new water pump?
Spread gasket sealant onto the new water pump’s mounting surface and to the engine side of the gasket. Apply a thin coat of clean engine oil or spray lubricant to all the bolts and studs except the bolt that goes into the bottom hole. Insert two bolts on opposite sides of the pump. Slide the pump with the two bolts into place against the engine.
How do you replace a Loctite water pump?
place the loctite blue on about half way end of all water pump bolts…replace all water pump and thermostat housing bolts CORRECTLY, and torque to specifications… tighten the 10 bolts in a cross sequence. put pulley back on with belt in position and tighten the three bolts on pulley.
Can a water pump be replaced on a Ford?
Sponsored Links Owners of Ford vehicles that use certain Duratec V6 engines are looking to Ford to help cover repair costs for water pump failures on the car. According to a class action Ford lawsuit, the typically inexpensive water pump replacement on other vehicles can cost many times more for a Duratec V6 engine.
How much does it cost to replace a water pump?
One plaintiff in the class-action lawsuit filed in late 2018 claims that he received a $3,000 repair bill to replace the entire engine. One man received a $1,800 bill for replacing the water pump, but the shop told him they suggested that the engine be replaced.
Where is the water pump on a Duratec V6?
The reason for this is that unlike most engines where the water pump is on the outside of the engine and easy to access, the Duratec V6 has a water pump that is inside the engine and driven by a chain. One plaintiff in the class-action lawsuit filed in late 2018 claims that he received a $3,000 repair bill to replace the entire engine.
What was the bill for replacing the water pump?
One man received a $1,800 bill for replacing the water pump, but the shop told him they suggested that the engine be replaced. One plaintiff on the case says that the shop told him they would be unable to guarantee that other damage inside the engine hadn’t occurred with the water pump failure.