How to remove the front bumper on a Nissan Rogue?
Use care when handling to prevent damage. Avoid contact with oily substances. Remove front grille. Refer to EXT-23, “Removal and Installation”. Remove front bumper fascia clips (A). Remove front bumper fascia clips (A) and screws (B). Partially remove front fender protectors (LH/RH).
How do you remove rear bumper from Nissan?
1. Remove this clip from the interior of your trunk on the left and right hand side. This will give you access to the screws holding in your tail lights. Be careful with these clips, they break easily! 2. Unscrew these two screws here as I have aleady done. I just used some pliers. 3.
How do you remove a front bumper fascia?
Release front bumper fascia pawls from front bumper fascia side brackets (LH/RH) and remove. CAUTION: When removing front bumper fascia, two people are required to avoid damaging. Remove front bumper fascia bolts (A) and the front bumper side bracket (1) (LH/RH) (if necessary). Remove intelligent key warning buzzer.
How do you remove a bumper without headlights?
Just use a phillips screwdriver in the “gear” on the adjusting screw. It is easily accessible without pulling the headlights. The bumper can be removed in <15 minutes, really quite easy to do, it gives you more room to work.
Use care when handling to prevent damage. Avoid contact with oily substances. Remove front grille. Refer to EXT-23, “Removal and Installation”. Remove front bumper fascia clips (A). Remove front bumper fascia clips (A) and screws (B). Partially remove front fender protectors (LH/RH).
How to install a Nissan Rogue front door?
Disconnect the harness connectors from the front door. Remove front door harness grommet, then harness from the front door. Remove front door check link bolt (body side). Remove front door hinge nuts (door side) and front door assembly. Installation is in the reverse order of removal.
How to remove the hood lock on a Nissan Rogue?
Radiator core lower support CAUTION: When removing radiator core support upper, be careful not to damage the painted surface. Remove front combination lamp (LH). Refer to EXL-119, “Removal and Installation”. Remove front air duct. Refer to EM-24, “Exploded View”. Remove hood lock. Refer to DLK-253, “HOOD LOCK : Removal and Installation”.
How to remove baffle foam from Nissan Rogue?
The front fender baffle foam adheres the front fender to the body side outer. Carefully release the baffle foam or damage to the front fender may occur. Installation is in the reverse order of removal.