How to remove the camshaft position sensor from a Hyundai Santa Fe?
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the camshaft position sensor connector (A). 3. Remove the installation bolt (B), and then remove the sensor. 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the camshaft position sensor connector (A). 3.
What should I do about my Hyundai Santa Fe?
Hyundai Santa Fe: Camshaft Position Sensor (CMPS). Repair procedures Hyundai Santa Fe DM 2013-2018 Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS). Repair procedures 1.
What is the input speed sensor on a Santa Fe?
Description Input speed sensor (A) is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the Transaxle Control Module (TCM). The sensor Drive Plate. Repair procedures
How do you remove a camshaft position sensor?
You should make out the plug with the wire and see that the sensor is being mounted with 1 10mm bolt. 1. Disconnect negative battery cable. 2. Disconnect wire connector from sensor. 3. Remove sensor mounting bolts. 4. Remove the sensor from the rear of cylinder head. 1. Install camshaft position sensor in rear of cylinder head. 2.
Is the Hyundai Santa Fe camshaft position sensor genuine?
We offer a full selection of genuine Hyundai Santa Fe Camshaft Position Sensors, engineered specifically to restore factory performance. Please narrow the Cam Position Sensor results by selecting the vehicle.
Hyundai Santa Fe: Camshaft Position Sensor (CMPS). Repair procedures Hyundai Santa Fe DM 2013-2018 Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS). Repair procedures 1.
Why is my camshaft position sensor not working?
Since it says circuit, that means the problem could lie in any part of the circuit – the sensor itself, the wiring, or the PCM. Don’t just replace the CPS (camshaft position sensor) and think that will definitely fix it.
Where is the camshaft position sensor on a Honda Accord?
elynbert, the camshaft position sensor monitors the position of the camshaft. It is mounted at the right hand side (looking from the front of the engine)of the cylinder head. You should make out the plug with the wire and see that the sensor is being mounted with 1 10mm bolt. 1. Disconnect negative battery cable. 2.
When to remove the camshaft position sensor ( CMPs )?
DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns. 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
What are the components of a Hyundai Santa Fe?
Variable Intake Solenoid (VIS) Valve 23. Fuel Pressure Regulator Valve 24. Canister Close Valve (CCV) 25. Ignition Coil 26. Main Relay 27. Fuel Pump Relay 28. Data Link Connector (DLC) [16-Pin] 29. Multi-Purpose Check Connector [20-Pin] 1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3.