How to remove front passenger axle shaft in Toyota?
There are apparently grooves on the base going into the transmission which can be used as attach points for the Toyota slide hammer, I’d guess you could rig something up with one from a Auto Parts store. Then, once everything is out they have you taking off the snap ring and bolt holding the shaft to the bearing bracket.
Can a CV axle be replaced on a Toyota Camry?
Here’s a video on the passenger side cv axle replacement performed on a Toyota Camry. This is a longer axle where the axle is “split” in the center by a support bearing. Here’s a video of a axle shaft removal and seal replacement on a Toyota Highlander.
Where is the CV bearing housing on a Camry?
The Camry inner CV axle is recessed into the differential allowing no room to position a pry bar to “pop” the axle out. However, the inner CV bearing housing has three prongs or “ears” that provide a place where a pry tool can push.
Where is the snap ring on a Toyota?
I took off the snap ring first with a pair of pliers, from under the car. The snap ring is found at the bracket everyone is referring to with 3 bolts. Take the ring off, and you can use tap the axle from the other side of the bracket outward towards the passenger side.
What’s the best way to remove an axle?
1) Buy the best slide puller you can find, with a heavy slide hammer weight to help pull the axle. If this helps pull the axle, you are good to go. 2) If you can’t pull with a slide hammer, prepare to drop the exhaust to obtain easy access to the axle. You will probably end up cutting the axle to remove it. So, what happened?
How does the automatic disconnecting system on a Toyota truck work?
The Automatic Disconnecting Differential system. There is a pneumatic device called an “actuator” attached to the front differential that effectively slides the driver side shaft out of the differential. On trucks that have ADD Toyota uses “live hubs” (see hubs section below).