How to relocate the rear turn signals on a Harley?
Unscrew the nuts from the turn signal’s mounting studs on the bottom of the rear fender, using a socket wrench. Pull the turn signals and their wiring off of the rear fender’s frame rails. Unscrew the stock license plate bracket’s bolts, using a socket wrench.
How do you install a turn signal on a car?
Slide the rear turn signal’s wiring through the new license plate bracket’s mounting holes. Loosely tighten the turn signal’s nuts against the bracket, using a socket wrench. Push the turn signal’s wiring through the holes on the rear fender’s stock license plate mounting points.
Do you need forscan to reprogram rear camera?
The video image sent by the video camera is then digitally zoomed in or out. braxx is right, a special procedure is required to initialize the camera. It is not available in FORScan yet, but we are ready to implement it for you if you can test it with your vehicle.
What does fixed guidelines on rear camera do?
The video camera fixed guidelines feature displays guidelines on top of the video image to assist the driver with alignment of the vehicle. A dashed line on the displayed image represents the center of the vehicle and 3 color-coded lines (red, yellow, green) identify different zones between the rear of the vehicle and objects.
What to do when rear turn signal is removed?
SMART Signal Stabilizer™ or Load Equalizer required when rear turn signals are removed on 2013-Earlier Touring models to ensure proper turn signal function and flash speed. Caution: Check local and state laws before removing OEM turn signals. If your state requires turn signals, add DOT compliant units to your vehicle.
Slide the rear turn signal’s wiring through the new license plate bracket’s mounting holes. Loosely tighten the turn signal’s nuts against the bracket, using a socket wrench. Push the turn signal’s wiring through the holes on the rear fender’s stock license plate mounting points.
Where are the turn signals on a Harley Davidson?
Rotate the turn signals until they are level, then tighten their mounting nuts with a socket wrench. Bolt the license plate bracket into place on the rear fender, using a socket wrench. Push the turn signal’s wiring through the rear fender and into the tail lamp housing. Plug the connectors into the appropriate prongs.
What kind of turn signal eliminator do I Need?
For additional visibility, upgrade to the Tri-Radius Turn Signal Eliminator Kit which provides both LED license plate illumination and 20 dual intensity red LEDs flush mounted on each side! Red Dual Intensity LEDs can be wired to function as run, brake, and turn on bikes with OEM rear 1157 turn signals (models without a center taillight).