How to relearn the PassLock sensor data code?
Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF. Turn OFF the ignition, and wait 5 seconds . Repeat steps 1 through 4, 2 more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
What to do if your PassLock light does not turn on?
Insert the Key into the ignition switch and try to start the car. It should start, and then stall, with the “SECURITY” light flashing. (In rare cases, the car may keep running and the security light will not illuminate, but that only happens if you are very lucky.)
What are the colors for Phase 3 wiring?
Phase 3 – Phase 3 wiring should be yellow. Neutral – Neutral wires should be grey. Ground – Ground wiring should be green, or green with a yellow stripe. These are the wire color coding standards that are used in the United States. In Europe and other countries, there are different standards in place.
Are there different color codes for electrical wiring?
In Europe and other countries, there are different standards in place. In most cases, a machine made overseas for use in America will be wired according to US color standards. Taking the time to confirm this is the case before using the machinery is always a smart safety step.
Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF. Turn OFF the ignition, and wait 5 seconds . Repeat steps 1 through 4, 2 more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
What should I do if I get 5 volts on my PassLock?
You should see 5 volts. If you don’t get that voltage, check for an open or short between the dark blue wire and the PCM that supplies the voltage to the module. If you DO get the 5 volts, turn the ignition off and reconnect the electrical connector. Pierce the insulation on the same wire (with a pin) or back-probe the wire in the connector.
Phase 3 – Phase 3 wiring should be yellow. Neutral – Neutral wires should be grey. Ground – Ground wiring should be green, or green with a yellow stripe. These are the wire color coding standards that are used in the United States. In Europe and other countries, there are different standards in place.
Insert the Key into the ignition switch and try to start the car. It should start, and then stall, with the “SECURITY” light flashing. (In rare cases, the car may keep running and the security light will not illuminate, but that only happens if you are very lucky.)