How to read the flashing light on the airbag?
It’s really simple – ground the correct pin the diagnostic connector under the steering wheel/dash, it’s super simple. just ground one pin and then read the flashing light. specifically i’m unsure and have a meeting in 19 minutes then my night is shot after that.
What is the code for the seat belt tensioner?
Learn More. Discussion in ‘ LR3 ‘ started by calibre, May 17, 2010 . I recently had a red airbag light on in the dash. Had the code read at 2 places – both say the driver seatbelt tensioner. They are saying it is the buckle part, which apparently compresses/tightens during an impact. $250 for the part, $50 labor.
Why does my airbag light keep turning on?
● Broken or damaged parts: The Airbag light may illuminate due to one or more damaged components. It can happen due to a variety of reasons including old or worn-out components mainly due to poor maintenance and water seeping into the vehicle. One of the major components that may cause the light to turn on is the clockspring.
How much does a bad seatbelt tensioner cost?
Trouble codes are showing a bad passenger seatbelt tensioner with repair cost of $400. The ironic thing is that just prior to the light appearing I had a tall driver move the driver’s seat back pretty far. Could this also be a connector issue?
What does the airbag warning light mean on a car?
In other words, if the airbag warning light is on, it may be signaling an issue with either the seat belts, the seat sensors, or the airbags themselves. Now that you understand what the airbag warning light means, you may be wondering what to do if the light stays on.
Learn More. Discussion in ‘ LR3 ‘ started by calibre, May 17, 2010 . I recently had a red airbag light on in the dash. Had the code read at 2 places – both say the driver seatbelt tensioner. They are saying it is the buckle part, which apparently compresses/tightens during an impact. $250 for the part, $50 labor.
How to fix the seat belt pretensioner light?
17) Plug the yellow connectors together reconnecting the pre-tensioner to the car. I rigged it up so I could plug in the seat while it was sitting outside next to the door.
What to do if your airbag light is still on?
If your airbag light is still on then you’re going to need to order the pre-tensioner. Bolt everything back together for now until you get the new parts. 21) Assuming the lights off it’s now time to put everything back together. 22) Disconnect the battery and then disconnect the seat wiring.