How to install throttle body on Jeep Patriot?

Chrysler Jeep Patriot Throttle Body Install. Limp Mode and Rough Idle – YouTube Chrysler Jeep Patriot Throttle Body Install. Limp Mode and Rough Idle If playback doesn’t begin shortly, try restarting your device.

How much does it cost to repair a jeep throttle control?

To fix an electronic throttle control costs between $580-$700, including jeep electronic throttle control repair cost. A mechanic’s labor costs between $100-$125, minus taxes and fees, and repairs in other parts may also be required.

Is there a problem with my Jeep Patriot?

… I have a problem with my jeep patriot 2008, 3 weeks ago the ETC (electronic throttle control) and Traction Control light turn on and I lost engine power, It just ran idle. It can not go more than 2000 RPM. I turn it off and on and it was everything ok. Now it started again with the problem, but turning off an on does not solve the problem now.

How does the throttle body work on a Jeep Compass?

Most modern throttle bodies have electrical components, such as a throttle position sensor. These components are monitored by the powertrain control module (PCM). If the check engine light or reduced power warning light comes on, a mechanic will determine if any of the stored trouble codes implicate a throttle body malfunction.

Is there a problem with the throttle control on my Jeep?

The Jeep continues to run perfectly, this is just an annoyance. Well, I think I may have finally fixed the electronic throttle control light problem on my Jeep. This has been a problem for the past several months. The ETC light would come on several times a week.

Why is the throttle blade on my Jeep Patriot going bad?

Dodgy plugs or coils would most likely give a CEL and misfire codes, not an ETC. Have the throttle body cleaned first. the throttle blade may be sticking on carbon build-up. I’ve done this twice after the ETC light comes on and it cures it.

Why is my Jeep Patriot in limp mode?

2014 Jeep Patriot has gone into limp mode with Throttle light, traction control light, and check engine light on. Car loses power and runs rough. Replacing the throttle body to solve issue. Loading…

What happens when you let off the gas on a Jeep Patriot?

When holding a steady throttle or accelerating up hill or on flat ground it sometimes shudders like you let off of the gas pedal and then got back on it, sometimes this is accompanied by the ETC light (lightning bolt with lines on each side of it) flashing for a few seconds and then going away. Sometimes it doesn’t flash or light up at all.

What’s the problem with the throttle on a jeep?

I went back and they said that the throttle position sensor faulty and the entire throttle body needed to be replaced. So, they ordered one and installed it. They then told me that when they tested it, the computer said that it was only at 75% throttle when they were in fact giving it full throttle.

What are the symptoms of a bad throttle body?

If your Jeep Patriot has a bad throttle body, it can cause it to run terribly. Common symptoms of a bad throttle body include, dirt and grime, the check engine light, and an erratic idle. Your Patriot’s throttle body controls the amount of air that enters the engine. You control the throttle body position with the gas pedal.

How does a dual battery isolator work in a car?

Whichever battery you choose is connected directly to the engine, alternator and accessories. The switch lets you drain one battery, then switch to another to start the engine. You must then switch to “both” in order to charge both batteries or have a separate diode-type battery isolator.

What are the cons of a dual battery isolator?

Cons: Requires user to manually switch between batteries. Heavy battery cables must be run to the switch. The solenoid isolator uses a continuous duty solenoid to connect the auxiliary battery during certain times (like starting and charging) then disconnects when not in use.

Navigation