How to install Mopar foglights on a jeep kJ?
1) If you want your fog lamps to stay on with brights and marker lights, splice the violet wire on the mopar harness into the Black/Yellow wire on your left front marker/turn signal lamp instead of violet on your headlamp. Click to expand… Does that work on factory fogs? I assume it is same setup?
How can I get my Mopar fog lamp to stay on?
1) If you want your fog lamps to stay on with brights and marker lights, splice the violet wire on the mopar harness into the Black/Yellow wire on your left front marker/turn signal lamp instead of violet on your headlamp. 2) I wasted hours trying to pull the terminal from the multi-switch harness.
Do you have to drill hole for Mopar foglights?
No need to drill a hole when there are already two nice ones put there by the manufacturer: factory firewall penetration. And if you have a decent flat-tip screwdriver that should be enough to pop the plastic insert out on the cabin side. Slightly North of the 49° th.
Where does the yellow wire go on a fog lamp?
Connect the YELLOW wire to the yellow switch wire terminal and to the relay terminal labeled 85. Test the operation of the lamps as follows: Re-connect the battery. Turn on ignition switch and low beam headlamps for Fog Lamps, or high beam headlamps for Driving Lamps.
How to wire fog and driving lights harness?
Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp low beam lead. Turn off the ignition and the headlamps. Disconnect the battery. For Driving Lights: Turn on the high beam headlamps. Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp high beam lead.
What should I do if my fog lamp is not working?
Test the operation of the lamps as follows: Re-connect the battery. Turn on ignition switch and low beam headlamps for Fog Lamps, or high beam headlamps for Driving Lamps. Activate auxiliary lamp switch. If lamps do not illuminate, check fuses and all wiring connections.
How does a fog light hook up to a battery?
This hook up does away with the headlight lamp connection. Green wire connects directly to the battery to power switch / relay. Loosen the stud or bolts securing the fog or driving lamp to the bracket to adjust the lights up or down. Loosen the mounting bolts to the vehicle to adjust the lights left and right.