How to install a temperature sensor on a bike?
1) If unit is mounted to a bike already remove the drive side crank arm and chainwheel or chainwheel adapter. If your drive unit is not installed yet just skip this step. 2) Carefully remove the plastic reduction gear cover being careful to not lose the gasket or to get grease everywhere. This can be 5 or 7 screws depending on the unit
How can I Keep my bbs02 controller from blowing?
When the motor starts being under high torque load and the RPM speed is slow the electricity flowing through the windings mostly turns into waste heat. The best way to keep your BBS02 from blowing is to mount a much smaller 32-36T chainring on it. The 2nd best way to keep your controller from frying is to install a temperature sensor.
How to troubleshoot an electric bike with no throttle?
On a true pedelec bike (no throttle), or an intelligent pedelec bike (with a load sensor hooked to the pedals or rear drop-out), the testing could be beyond the scope of this article. On those bikes, I strongly suggest you have a factory trained tech do your troubleshooting and repair. At minimum, talk to one on the phone to guide you.
What to do if your ebike controller is damaged?
SWITCH DAMAGED ON CONTROLLER. IF THE BATTERY HAS CHARGE, AND IS PROPERLY CONNECTED, THE ON/OFF SWITCH ON THE CONTROLLER MAY BE AT FAULT. REMOVING THE 4 SCREWS HOLDING THE SWITCH PLATE WILL GIVE ACCESS TO THE SWITCH. TEST/REPLACE IF NECESSARY. 1. Check that the e-brake lever is not damaged or engaged.
SWITCH DAMAGED ON CONTROLLER. IF THE BATTERY HAS CHARGE, AND IS PROPERLY CONNECTED, THE ON/OFF SWITCH ON THE CONTROLLER MAY BE AT FAULT. REMOVING THE 4 SCREWS HOLDING THE SWITCH PLATE WILL GIVE ACCESS TO THE SWITCH. TEST/REPLACE IF NECESSARY. 1. Check that the e-brake lever is not damaged or engaged.
Can a crankshaft sensor cause a car to backfire?
Modern cars now have engine control modules that will adjust the ignition timing of the car automatically, making spitting and backfiring very difficult to simulate. In rare circumstances, the crankshaft position sensor can go rogue and cause backfiring. That being said, modern cars can backfire, but only if designed to be able to do so.
Why is the ON / OFF switch on my ebike not working?
SWITCH DAMAGED ON CONTROLLER. IF THE BATTERY HAS CHARGE, AND IS PROPERLY CONNECTED, THE ON/OFF SWITCH ON THE CONTROLLER MAY BE AT FAULT. REMOVING THE 4 SCREWS HOLDING THE SWITCH PLATE WILL GIVE ACCESS TO THE SWITCH.
Why is my electric bike not charging properly?
1. CYCLE ANALYST SETTINGS MAY HAVE BEEN CHANGED CAUSING UN-INTENDED RESULTS. 2. MOTOR HALL SENSOR MAY HAVE BEEN DAMAGED. -CONTACT VESSEL BIKES FOR MORE INFORMATION ON TESTING FOR THIS CONDITION. 3. E-BRAKE MAY BE CAUSING THIS ISSUE IF ACCIDENTALLY BEING PRESSED. Q. Does pedaling re-charge the battery? A. Not really.