How to fix a Toyota sliding door motor?
The video for the “5 dollar fix” was very helpful. He really goes through the process thoroughly. I opted to get the part, because it saved me some trouble. One of the cautions he brings up is the screw that connects the motor to the door on the inside has softer metal than it should for the tension, so you need to be very careful not to strip it.
Why is the sliding door not working on my Toyota Sienna?
I have a 2006 Toyota Sienna Limited, and right away the door would not slide open automatically. After doing several searches online, I discovered that the sliding door actuator is a common problem in Siennas.
Where is the button on the side of the sliding door?
Note: At some point you will either want to disconnect the positive battery terminal from your battery or simply put the sliding doors in manual mode so you can manually open and close your sliding door as needed to complete the repair. The button to put the sliding doors in manual mode is located at the left knee of the driver:
How much does a sliding door motor cost?
Direct fit and fixed the problem with the door. Used a little bit of heat in order to not strip the existing screws (they are held in with Loctite). Found out later, however, that the little motor within is the root cause and its only $5 to replace. Wish I would have done that.
The video for the “5 dollar fix” was very helpful. He really goes through the process thoroughly. I opted to get the part, because it saved me some trouble. One of the cautions he brings up is the screw that connects the motor to the door on the inside has softer metal than it should for the tension, so you need to be very careful not to strip it.
What to do when your side door won’t open?
The only way you can get the door open is to pull the handle and then hold it for two or three seconds. This happens when the latch motor fails, which is fairly common in Toyota Siennas.
Direct fit and fixed the problem with the door. Used a little bit of heat in order to not strip the existing screws (they are held in with Loctite). Found out later, however, that the little motor within is the root cause and its only $5 to replace. Wish I would have done that.
Note: At some point you will either want to disconnect the positive battery terminal from your battery or simply put the sliding doors in manual mode so you can manually open and close your sliding door as needed to complete the repair. The button to put the sliding doors in manual mode is located at the left knee of the driver:
What are the drivers for a door module?
Door Module Drivers. The actuator drivers support all regular door-module loads such as window lifting, lock motors, mirror leveling, mirror retraction, defrosters, and several lighting functions from incandescent bulbs to LEDs. For high-end cars, a new electrochromic mirror glass control IP is available.
How to replace drivers side blend door actuator?
There is a single screw under then under the edge that is 7mm like the read and a deep 1/4 socket will remove it. Then the actuator you can get out as well, but with a shallow 5.5mm. THe alternative is taking the whole center console out which will take 2-3 hours, but you can replace the actautor this way. I have large hands and I could.
What is the definition of the driver’s side?
Definition of driver’s side : the side of the car where the driver sits The front door on the driver’s side is scratched. Learn More about driver’s side
There is a single screw under then under the edge that is 7mm like the read and a deep 1/4 socket will remove it. Then the actuator you can get out as well, but with a shallow 5.5mm. THe alternative is taking the whole center console out which will take 2-3 hours, but you can replace the actautor this way. I have large hands and I could.
How to install a new power window motor?
Installing a New Power Window Motor 1 Slide the new motor and regulator back into place. Insert the power window motor and regulator back into the main service port in the door in exactly the opposite order that you removed them in when disassembling the door.
What are the symptoms of a bad door lock actuator?
Usually a bad or failing power door lock actuator will produce a few symptoms that can notify the driver of an issue that should be serviced. 1. Unusual noises coming from inside the door Unusual noises coming from inside the door are one of the first symptoms of a potential problem with a power door lock actuator.
How to tell if a power door lock is a problem?
1. Unusual noises coming from inside the door. Unusual noises coming from inside the door are one of the first symptoms of a potential problem with a power door lock actuator. Most power door locks operate using gears or motors that may quietly whir, or make noise when they operate. Those noises are normal.