How to diagnose a Honda Accord airbag ABS?
HONDA ACCORD Diagnose instructions : 1 Find the OBD connector ( on board diagnostic connector ) located on the left side under the dash. 2 Find the number 4 and number 9 pins you can read it on the plug .
What does the ABS light mean on a Honda Accord?
The ABS light is different than the brake warning light itself. The brake light indicates that there is a problem with the physical braking system and that your Accord is unsafe to drive. Yes, you can drive your Accord with the ABS light on. Is it safe? It’s not as safe, especially when it’s raining, snowing, or the road surface is loose/uneven.
Where are the short pins on a Honda dash light?
Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. I used a paper clip, but any stiff (solid) light gauge wire will do. Click on the photo below right to expand and you can see the pin numbers marked in the plastic.
Where is the diagnostic port on a Honda Accord?
For the 1990 to 1995 Honda Accords, the diagnostic port is located by the passenger’s side kick panel. To access the connector, remove the panel using a Phillips screwdriver. For the 1996 to 2002 Honda Accords, the diagnostic port is located just bellow the bottom edge of the driver’s side dash.
HONDA ACCORD Diagnose instructions : 1 Find the OBD connector ( on board diagnostic connector ) located on the left side under the dash. 2 Find the number 4 and number 9 pins you can read it on the plug .
The ABS light is different than the brake warning light itself. The brake light indicates that there is a problem with the physical braking system and that your Accord is unsafe to drive. Yes, you can drive your Accord with the ABS light on. Is it safe? It’s not as safe, especially when it’s raining, snowing, or the road surface is loose/uneven.
Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. I used a paper clip, but any stiff (solid) light gauge wire will do. Click on the photo below right to expand and you can see the pin numbers marked in the plastic.
How do I get my Honda ABS to go off?
Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it). The ABS indicator will come on, but then should go off, at this point release the brake pedal (some have found better success by releasing the pedal quickly after the light comes on).