How to check the SRS code on a Mazda 929?

How to check the SRS code on a Mazda 929?

The information below may apply to Mazda 929 and many other models 1 Turn ignition ON. If codes exist the SRS warning light should come on & ‘prove out’, codes should then be displayed, (no need to bridge connector terminals). 2 Read codes on SRS light as described in the Code Format Description below.

What are the DTC codes for Honda SRS airbags?

Honda SRS Airbag DTC Codes. 1 Honda 1988-2002 All Models Codes: 1-1 & 1-2 open circuited Or high Resistance In Drivers Air Bag Inflator 1-3 short circuited To Another Wire In 2 Honda 2002-2011 All Models Codes: 3 Honda CIVIC, CR-V, ELEMENT & RIDGELINE Codes: 4 Honda ODYSSEY Codes: 5 Honda INSIGHT, PILOT S2000 Codes:

What does 34 mean on a Mazda Flash code?

34 = Driver’s side air-bag / safing sensor: low resistance or shorted 35 = Low resistance across pins 8 and 9 of DM 41 = Crash sensor circuit: high resistance or open

What are the Flash codes for a Mazda air bag?

13 = Air bag circuit or crash sensor shorted to ground 21 = Safing sensor mounted incorrectly 22 = Safing sensor: output shorted to battery voltage 23 = Safing sensor input feed or return circuit open

What does the SRS light on a Mazda mean?

The SRS light on a Mazda is designed to alert the driver to potential problems with the Supplemental Restraint System (SRS), which refers to the vehicle’s air bags.

The information below may apply to Mazda 929 and many other models 1 Turn ignition ON. If codes exist the SRS warning light should come on & ‘prove out’, codes should then be displayed, (no need to bridge connector terminals). 2 Read codes on SRS light as described in the Code Format Description below.

What is the trouble code for a Mazda 3s?

2004 Mazda 3S 2.3L – MIL came on and reader indicated P2177. System Too lean Off Idle Bank 1 Please see the attachment. It should explain my situation so far.

Where is the reset button on a Mazda SRS?

This should cause all electronic systems to reset to the original factory default settings. Disconnect the SRS air bag diagnostic connector, which is either under the dashboard on the driver’s side or under the hood in the upper corner near the windshield on the driver’s side. See photos in the Resources section.

Posted In Q&A