How to change the transmission on a Jeep Grand Cherokee?
Pry the transmission pan loose with a flathead screwdriver. Allow the fluid to drain. Remove the remaining bolts, pan and gasket. Clean the gasket surface, with a gasket scraper, to remove all traces of the old gasket and sealant. Drain the fluid from the transmission pan. Clean the pan with solvent. Dry the pan with paper towels or old rags.
Why does my Jeep Grand Cherokee not shift gears?
For example, you may find that you’re only able to drive the car in the automatic transmission’s third gear, only being able to select the other two gears when you shift the transmission manually. The most common cause of transmission problems is the easiest to fix: check the fluid level in the transmission and restore it to the proper levels.
What kind of transmission does a Jeep Comanche use?
AW4: A four speed automatic transmission was used in 1987 to 2001 Jeep Cherokee (XJ), & Jeep Comanche with 2.5L & 4.0L engines. It was also used in 1987 through 1992 Jeep Comanche & 1993 through 1993.5 Jeep Grand Cherokee with 4.0L engines.
What kind of transmission does a Jeep Wrangler have?
Jeep Automatic Transmission Guide. A summary of the automatic transmissions used in various Jeep vehicles. 42RLE: Four-speed automatic transmission was available from 2003 to 2006 Jeep TJ Wrangler with 4.0L engines. 45RFE: A four speed automatic transmission was used in 1999 Jeep Grand Cherokees with 4.7L engines.
How to remove automatic transmission from Jeep Cherokee?
Push the transmission over to the passenger side until the transfer case linkage comes free which will cause the whole unit to drop even farther. Disconnect electrical connections, breather lines, sensors, and shift linkages from the top of the transmission.
For example, you may find that you’re only able to drive the car in the automatic transmission’s third gear, only being able to select the other two gears when you shift the transmission manually. The most common cause of transmission problems is the easiest to fix: check the fluid level in the transmission and restore it to the proper levels.
How much does it cost to repair a jeep transmission?
Typically, you can expect to pay between $1,800 and $3,400 for a transmission replacement, while the Jeep transmission repair cost for one part may be less than $1,000. The Jeep Cherokee is a specific line of SUVs produced by Jeep spanning five generations over 40 model years.
How do you change transmission fluid in a jeep?
The original procedure for the trans is to fill with a certain amount, get the trans to a certain temp, open a weep hole plug and then drain or fill till the trans weeps fluid from the weep hole for 3 minutes, while its running.
What kind of transmission does a jeep have?
Certified Transmission offers remanufactured units for Jeep models that include the Compass, Grand Cherokee, Laredo, Liberty, Pickup, Wagoneer, and Wrangler. The models of Jeep transmissions in Certified Transmission’s inventory includes A518, 45RFE, A500, TF6, TF8, TH400, and 42RLE.
How to adjust the rear band on a Jeep Grand Cherokee?
Drain the fluid from the transmission pan. Clean the pan with solvent. Dry the pan with paper towels or old rags. Locate the rear band adjusting screw on the rear band lever. Loosen the the adjusting screw locknut four turns with a ratchet and socket. Make sure the screw turns freely in the lever.
Why is my Jeep Grand Cherokee not shifting?
Matthew Wright has been a freelance writer and editor for over 10 years and an automotive repair professional for three decades specializing in European vintage vehicles. There is a common issue with shifting on a number of Jeep Grand Cherokee models as they age and their mileage increases.
Can a Jeep Grand Cherokee Drive in two gears?
You’re often still able to drive the vehicle, but it only operates in one or two gears. For example, you may find that you’re only able to drive the car in the automatic transmission’s third gear, only being able to select the other two gears when you shift the transmission manually.
What does trouble code mean on Jeep Grand Cherokee?
A trouble code is a code thrown out by an automatic transmission whenever it detects in the Grand Cherokee that there is an issue that needs your attention. In the case of the P0700, it is a general code. This means that it should be accompanied by some other code that should tell you the specific problem.
What kind of transmission does a 1999 Jeep Grand Cherokee have?
1999 and 2000 model year WJ owners can have their 45RFE transmission’s programming flashed to enable the extra gear as both transmissions are physically the same. The 42RE 4-speed automatic remained the transmission for the Inline 6 engine. It had slight changes from the previous model Grand Cherokee.
When did the Jeep Grand Cherokee 45RFE come out?
In June 1998, Chrysler introduced the innovative 45RFE in its 1999 WJ Jeep Grand Cherokee. Produced at Chrysler’s Indiana Transmission plant in Kokomo, it was paired with the 4.7 L PowerTech V8 engine.
How many rows does a 545RFE automatic transmission take?
Gear WA580 545RFE 65RFE 66RFE 68RFE 1 3.59 3.00 3.23 2 2.14 1.67 1.84 3* 1.41 1.50 1.41 4 1.00 1.00 1.00
What kind of transmission does a Chrysler 45RFE use?
The transmission was well suited for the large torque band of the Hemi V8, 3.7 V6, 4.7 V8, and VM 2.8 diesel. In 2009, the computer was programmed to let drivers select the highest gear the transmission would shift to, for easier towing, hill climbing, and hill descent. In 2012, Chrysler launched three new six-speeds, all based on the 545RFE.
Is it safe to drive a Jeep Grand Cherokee with transmission fluid leaking?
If your Jeep Grand Cherokee’s transmission is leaking directly from the transmission pan (far and away the most common area), than it is safe to drive. it should still be fixed right away. Enough transmission fluid leaking anywhere can be dangerous.
Is there a problem with my Jeep Grand Cherokee?
Very often, this will solve the problem. But Jeep Grand Cherokees seem especially prone to more serious transmission problems, and some owners are quite vexed at their inability to determine the causes.
What kind of transmission does a Jeep Grand Cherokee have?
44RE: A four speed automatic transmission was used in 1996 to 1998 Jeep Grand Cherokee’s with 5.2L engines. 42RE: A four speed automatic transmission was used in 1993.3 to 1998 Jeep Grand Cherokees with 4.0L engines.
You’re often still able to drive the vehicle, but it only operates in one or two gears. For example, you may find that you’re only able to drive the car in the automatic transmission’s third gear, only being able to select the other two gears when you shift the transmission manually.
What’s the gear ratio on a Jeep Grand Cherokee?
44RE: A four speed automatic transmission was used in 1996 to 1998 Jeep Grand Cherokee’s with 5.2L engines. Gear Ratios: 1st Gear: 2.74:1, 2nd Gear: 1.54:1, 3rd Gear: 1.00:1, 4th Gear: .69:1, Reverse Gear: 2.20:1 42RE: A four speed automatic transmission was used in 1993.3 to 1998 Jeep Grand Cherokees with 4.0L engines.